Wayne-Dalton 3150C Operating Instructions And Owner's Manual - Adv
6
Use this procedure to program your Keychain
Remote for up to 6 actions.
In any of the previous programming instruc-
tions at the point where you need to activate a
transmitter button to complete the programming
step, simply simultaneously press a combina-
tion of any two buttons. Then to activate that
programmed action, simultaneously press those
two buttons.
Example of Use: Single Big button is pro-
grammed only to activate Garage Door Opener,
while each of the two smaller buttons are
programmed to SCENE 1 and 2 of the Gateway
Module. SCENE 3 of the Gateway module can
be programmed to activate by pressing the two
smaller buttons at the same time.
Problem:
• The range of the transmitter is reduced.
Button Combinations
Troubleshooting
Solution:
Replace Battery:
To change the batteries, insert a coin in the
coin slot and twist to access the battery
compartment. Your transmitter may use one
or two CR2016 batteries. Remove the batteries
from the battery cage and replace with fresh
batteries. Be sure to maintain the correct
polarity (+).
Coin Slot
Press 2 Transmitter buttons
at the same time