We MS200 Basic Operation Manual - page 2
Audio jacks
USB ports
Power bu
tt
on
HDD status indicator
RJ45 connector
DVI-I output
HDMI port
IEEE 1394 port
MS200
ENGLISH
2
3
ENGLISH
Memory and Storage
Depending on the base so
ft
ware con
fi
gura
ti
on, the user may need only the internal HDD of the
MS200 for user’s installed so
ft
ware and storage. The user may also supplement storage space with
USB-based peripherals such as
fl
ash disks, disk drives, etc.
I/O Ports
Connec
ti
ng Peripherals
Insert the USB dongle to a USB port (1) and make sure your monitors are connected the MS200
with video cables (2). A
ft
er the peripherals are well connected, plug the power cord into the
MS200 (3) and insert the other end into a power outlet.
NOTE:
DO NOT connect the power cord before connec
ti
ng the USB dongle and all cables to the MS200.
Powering ON and OFF
The Power Bu
tt
on is located on the front of the MS200. To turn the MS200 on, push and release
the Power Bu
tt
on on the front bezel. The power LED will be lit (blue), and the corresponding
interface will be shown on the display monitors.
To turn o
ff
the device, use the so
ft
ware shutdown interface provided, or unplug the appliance.
In the event of system lockup, unplug or re-plug the power cable. Also, the Power Bu
tt
on may be
used to perform a reset on the device. To do that, push and hold the Power Bu
tt
on for at least
4 seconds. The system will shut down and all unsaved work may be lost. Pushing on the Power
Bu
tt
on again will restart the device.
Server Installa
ti
on
Please refer to the other documents inserted in the package to
start se
tti
ng up your WebDT Content Manager server via the
WebDT Content Manager CD.
Appliance Registra
ti
on
A
ft
er turning on the MS200 for the
fi
rst
ti
me, a screen prompt is
displayed for registering the player. If the screen prompt is not
shown, please follow the instruc
ti
ons below:
Press and hold “Control + Shi
ft
+ Space” to exit the WCM Player so
ft
ware.
1.
Navigate to Start | All Programs | DT Research | WebDT Signage Player
2.
Select Register WebDT Signage Player Again. The Player Registra
ti
on screen should appear. Fill in
3.
all
fi
elds to register. The required informa
ti
on is marked.
Click OK to register and connect to the WebDT Signage Appliance Publish Server.
4.
Insert the USB dongle.
Connect video cables (DVI/ HDMI)
with monitors.
Connect the power cord.
E
A
D
C
A
B
B
F G
B H B
A
A
B
C
D
E
F
G
H
MS200 Front
MS200 Rear