Weather-Rite XT112 Installation, Operation & Service Manual - page 86
S
ERIES
XT I
NSTALLATION
, O
PERATION
AND
S
ERVICE
M
ANUAL
80
23.1 Initial Checks
When encountering any abnormal operation or fault conditions of the equipment, all troubleshooting should
start with the following initial checks. If a problem is discovered in these initial checks it must be corrected
before moving on in the trouble shooting.
1. Compare
voltage and phase of supply power on site with rating plate information.
2.
Review wiring between remote panel and control panel. Do the electrical connections match the sup-
plied wiring diagram?
3.
Compare gas type and supply pressure on site with rating plate information.
4.
Check for proper blower rotation on air handler and any exhaust blowers.
• Blowers powered with a three phase motor can be reversed by swapping any two incoming power
legs. For blowers powered by a single phase motor refer to the motor rating plate for reversing
instructions.
23.2 Motor and Blower
PROBLEM
POSSIBLE CAUSE
SOLUTION
Motor does not operate
Main disconnect switch is OFF
Turn disconnect to ON
Blown fuse(s) in disconnect
Replace fuse(s)
Blown fuse(s)/breaker tripped in control transformer Replace fuse(s)/reset breaker (with
disconnect off)
Fan switch on
Check wiring between remote panel
and air handler. Replace switch.
Optional: Damper does not open
Check that damper is not obstructed
Check that linkage is tight and
secure
Replace damper actuator
Motor starter (contactor) does not operate.
Replace starter
Tripped motor overload. Power out to MUA motor
when motor starter is energized?
Reset
Check for proper FLA setting
Replace overload
If applicable: Tighten screws on
heater packs or overload.
Optional: Low limit switch set to high
Re-adjust low limit switch setting
Blower does not operate
Belts broken or loose?
Replace/tighten belts
Loose motor or blower sheaves (pulleys)
Reinstall and properly torque set-
screws
Blower bearings, do they turn freely?
Replace bearing(s)