User’s guide v:1624-0103-12 for the most up-to-date version of this user’s guide, go to www.Weather-x.Net wr882r multi-function power station.
22 warning: changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. Note: this equipment has been tested and found to comply with the limits for a class b digital device, pursuant to part 15 of the...
Customer support: 1-888-999-4215 3 introduction siren press to turn the siren on or off. Fm/wb/am adjust to switch between fm, wb and am radio modes. Power adjust to power the unit on or off. Line in usb output circuit breaker charge indicators dc output volume adjust the dial to turn the volume up ...
4 compass flashlight/lantern adjust the switch to switch between flashlight, emergency, lantern, and off modes. Lantern pull upwards gently to adjust the position of the lantern. Flashlight release latch release latch to remove flashlight flashlight mosquito repellent press to turn the mosquito repe...
Customer support: 1-888-999-4215 5 to power the unit, plug the included ac/ dc adapter into a standard ac outlet. Note: unit must be charged for a minimum of 10 hours before initial use. Requires 3 aa batteries (not included). Ac power flashlight power to power the unit, plug the included dc adapter...
6 power charging indicators the indicators represent the level of charge held by the internal rechargeable battery, which can also be charged by the dynamo hand-crank. Warning: the unit’s button cell battery contains mercury. Do not put in the trash, instead recycle or dispose of as hazardous waste....
Customer support: 1-888-999-4215 7 clock, radio and weatherband setting the clock 1. If the radio is on, turn the volume dial to off. 2. Press and hold the set button. 3. While holding the set button, press the min button repeatedly to adjust the minutes. 4. While holding the set button, press the h...
8 charging, circuit breaker and 3.5mm audio input using the audio input requires a 3.5mm audio cable (included) 1. Connect a 3.5mm audio cable to the 3.5mm audio input and the audio output on an mp3 player or other audio device. 2. Adjust the power switch to on. 3. Turn the volume dial to turn on th...
