Weatherworks F1PJYA51WG Owner's Manual - page 4
ASSEMBLY OF BLADE AND GRILLES (#1-7)
1. Fig. 5A:
Remove and discard the plastic sleeve on the motor shaft (Part #7). Position the rear grille (Part #6) against the front
of the motor housing (Part #8) through the motor shaft (Part #7). Ensure that the handle at the back of grille is facing
up and that all guiding pegs on the motor housing are lined up with cutouts on the rear grille (Part #6).
Fig.
5B:
Secure the rear grille (Part #6) into place with the plastic nut (Part #5). Fasten the plastic nut (Part #5) firmly onto the
motor housing (Part #8) by tightening it in a CLOCKWISE direction.
2. Fig. 6A:
Install the fan blade (Part #4) onto the motor shaft (Part #7) with the cutouts fitted.
Fig. 6B:
Place spinner (Part #3) on the motor shaft (Part #7) after the blade (Part #4).
Fasten into place by tightening the spinner (Part #3) COUNTER-CLOCKWISE direction.
6B
6A
Fig. 6
5B
5A
Fig. 5
3. Fig. 7A:
On the bottom of the plastic grille band (Part #1) loosen, BUT DO NOT REMOVE the setting screw with a screwdriver.
Fig. 7B:
Hook the band around the rim of the rear grille (Part #6) and note there are two thin rails inside of the plastic grille
band (Part #1). Ensure the entire rim of rear grille is on the further rail. Then put the front grille to the band and
carefully click the entire rim of front grille into the front rail of the band. Ensure the setting screw is centered at the
bottom of the grilles.
Fig. 7A
Fig. 7B
WEATHERWORKS
F1PJYA51WG
4