Webasto BlueHeat Installation Instructions Manual - page 8
5
2004 Lexus RX330 3.3 Liter V-6
Timer Installation - Model 1533
ATTENTION
Before installing the timer, please confirm the
installation site with your customer.
CAUTION
Before drilling into any panels, ensure there are no
hidden components behind the panel that may be
damaged or interfere with the timer installation! If
necessary, to avoid damaging components, remove the
panel before drilling holes.
ATTENTION
DO NOT OVERTIGHTEN MOUNTING SCREW!
Overtightening mounting screw will cause stress on the
timer resulting in irreparable damage to the LED display.
Position 9
– Timer installed (See translated template for
instructions, refer to figure 14).
– Screw DIN7981 B3.5x19
– Timer harness connector (Click in)
– Tighten mounting screw - max. 0.8 Nm (7.0 lb-in.).
Ignition ‘On’ Fuse Tap Connection
Position 10 and 11
– Route the blue fuse tap wire to fuse panel.
– With a test light, find an “Ignition ON” power source.
Test light must be off when ignition key is in the OFF
position.
– Using the supplied fuse tap connector, tap into the
“fused”side of the selected fuse.
Timer
Installation
Ignition ‘On’
Fuse Tap
Installation
Fig.
9
Fig.
Fig. 15
Fig.
Fig. 14
Fig. 16
10
11