Webasto FCF 10 Installation And Operation Manual - page 23
23
5.2 Power ON/OFF
◆
Press ON/OFF button to turn the unit on
◆
Pressing the ON/OFF button a second time will turn the unit off
5.3 FAN Control
◆
Press the FAN button, the fan speed will change in the following order:
◆
In “DEHUMIDIFY” mode, the fan will work at low speed automatically.
5.4 Temperature Setting
◆
Press temperature setting key:
To increase in 1°C increments;
To decrease in 1°C increments.
◆
The setting range of temperature in each mode:
COOL
61°F~86°F or 16°C ~30°C
DEHUMIDIFY
61°F~ 86°F or 16°C~30°C
HEAT
61°F~86°F or 16°C~30°C
FAN
In this mode, temperature cannot be changed.
AUTO
68°F~78°F or 20°C~26°C
5.5 Mode Setting
◆
Press this key to change the operation mode in order of
◆
In “COOL” mode, the LED marked
will be light, if set temperature is higher than room temperature,
only the fan will run.
◆
In “DEHUMIDIFY” mode, the LED marked
will be light and fan will work at low speed within a certain
temperature range. Dehumidifying is more efficient than in cooling mode and it will save energy.
◆
In “FAN” mode, all LED marked work pattern will extinguish, and hand controller will indicate room
temperature. But this temperature cannot be set
◆
In “HEAT” mode, the LED marked
will be light ,when the setting temperature is lower than the room
temperature, it will not run.
◆
In “AUTO” mode, the LED marked AUTO will be light
。
COOLING ONLY TYPE WITHOUT HEAT MODE.
5.6 Display Fahrenheit or Centigrade
Pressing MODE and
key simultaneously for 5 seconds, the temperature can switch between Fahrenheit and
Centigrade modes.