Webasto Telestart Operating And Maintenance Instructions - page 3
The Webasto heaters – Thermo Top, Thermo Top T, Thermo Top C and Thermo Top E –
as well as the vehicle fan can be switched on and off under remote control from a
distance of up to 600 metres with the Webasto Telestart T70/T80.
A mode change must be made on the transmitter in order to switch on the vehicle fan
(ventilation of the vehicle).
The duty period after switching on via the transmitter is limited by the receiver. The
maximum range can be reached in open country. A shorter range must be expected in
built-up areas.
OFF
OFF
ON
ON
LED
LED
NOTE:
A minimum distance of 2 metres must be maintained between the
handheld Telestart transmitter and the vehicle antenna
or
the antenna on the handheld transmitter must be shielded with the other
hand when
- learning the Telestart handheld transmitter,
- switching the heater on and off,
- switching the vehicle fan on and off.
!
Min. 2 m
Antenna
Telestart T70
Telestart T80
General
Learning the Telestart transmitter
Check mode
Change mode
Simultaneously press ON and OFF buttons twice within
one second.
The selected mode (heating or ventilation) is only set in the
receiver when the next signal is transmitted.
The LED changes colour when the buttons are pressed
for the second time and remains lit until the buttons are
released.
Press and hold ON and OFF buttons simultaneously.
LED lights up:
LED goes out:
when the buttons are released or
after 10 seconds.
Heating mode
Ventilation mode
red
green
=
=
-
-
2 x
1.
2.
3.
4.
5.
Place batteries in the battery compartment of the transmitter.
Remove 1 A fuse (black) from the heater fuse holder (interrupt power supply).
Wait for at least 5 seconds.
Refit fuse in heater fuse holder and press OFF button on transmitter for
at least 1 second within the next 5 seconds.
Learning is complete.
A second or third handheld transmitter can be learned in the same way.
Min. 1 s
OFF
1 A
1 A
25A
15A
1A
25A
15A
1A
Min. 5 s
Max. 5 s