Webasto ThermoCall TC4 Installation Instructions Manual - page 12
ThermoCall TC4
6
Connection of an alarm
system installed in the vehicle
(Advanced)
The vehicle owner receives a text
message when the alarm system is
triggered.
Insert the wire in Pin 7 of the 12-pin
connector and connect it to the output
of the alarm system (must be a +12 V
signal).
To define which text message
content the ThermoCall TC4 is to use
to inform you, send the following
text message command to the
ThermoCall TC4 following initial
start-up:
1234IBANK:"Entry
command"
. The entry command
can, for example, be Alarm.
The alarm can be sent to up to 5
phone numbers. To define which
phone numbers are to be used, send
the following text message
command to the ThermoCall
TC4:
1234NBANK:XXX:YYY:ZZZ:
VVV:WWW
XXX:YYY:ZZZ:VVV:WWW = phone
numbers to be entered by the user,
e.g.:
+436641234567:+4369912345678
: etc.
Connection of an external
temperature sensor
(Advanced)
This is required for measuring the
temperature outside the ThermoCall
TC4 (e.g. for cargo areas) and for
using the temperature alarm
function.
Required material:
-W bus temperature sensor 9023181A
(not required in combination with
Telestart T100 HTM)
-Y-adapter 9001505A (only required if
a control element is connected after
the ThermoCall TC4)
-See the Webasto Accessories Cata-
logue for any required extensions.
Carry out the connection as shown in
the following drawing and illustrations
on the inner cover pages.
To use the temperature alarm, the
phone numbers to be notified must
be reported to the ThermoCall TC4.
To define the phone numbers, the
following text message command
must be sent to the ThermoCall TC4:
1234NBANK:XXX:YYY:ZZZ:VVV:
WWW
XXX:YYY:ZZZ:VVV:WWW = phone
numbers to be entered by the user,
e.g.:
+436641234567:+4369912345678
: etc.
For details, see operating
instructions.