WebDT MS400 Basic Operation Manual - page 2
Audio jacks
USB ports
Power button
Serial Port
IEEE 1394 port
RJ45 connector
Mini DisplayPorts
MS400
ENGLISH
2
3
ENGLISH
Memory and Storage
Depending on the base software configuration, the user may need only the internal HDD of the
MS400 for user’s installed software and storage. The user may also supplement storage space with
USB-based peripherals such as flash disks, disk drives, etc.
I/O Ports
Connecting Peripherals
Connect the mini DP-to-DVI cables to the graphic card outputs (1) and make sure your monitors are
connected the MS400 with DVI-D cables (2). Then insert the USB key to a USB port (3). After the
peripherals are connected, plug the power cord into the MS400 (4) and insert the other end into a
power outlet.
NOTE: DO NOT connect the power cord before connecting the USB dongle and all cables to the MS400.
Powering ON and OFF
The Power Button is located on the front of the MS400.
To turn the MS400 on, push and release the Power Button on the front bezel. The power LED will
be lit (blue), and the corresponding interface will be shown on the display monitors.
To turn off the device, use the software shutdown interface provided, or unplug the appliance.
In the event of system lockup, unplug or re-plug the power cable. Also, the Power Button may be
used to perform a reset on the device. To do that, push and hold the Power Button for at least
4 seconds. The system will shut down and all unsaved work may be lost. Pushing on the Power
Button again will restart the device.
Server Installation
Please install the WebDT Content Manager server software from
the WebDT Content Manager CD and follow the detailed steps
described in the User Manual file included in the WebDT Content
Manager CD.
Appliance Registration
After turning on the MS400 for the first time, a screen prompt is
displayed for registering the player. If the screen prompt is not
shown, please follow the instructions below:
Press and hold “Control + Shift + Space” to exit the WCM Player software.
1.
Navigate to Start | All Programs | DT Research | WebDT Signage Player
2.
Select Register WebDT Signage Player Again. The Player Registration screen should appear. Fill in
3.
all fields to register. The required information is marked.
Click OK to register and connect to the WebDT Signage Appliance Publish Server.
4.
<1>
<2>
<3>
<4>
Connect the mini
DP-to-DVI cables to
the graphic card.
Connect the MS400
with DVI-D cables.
Insert the USB key.
Connect the power cord.
F
E
C
B
D
B
A
B
B
G
A
B
A
B
C
D
E
F
G
MS400 Front
MS400 Rear