Webee 3323 Getting Started - page 4
Webee-Centralite-3323
GETTING STARTED WITH MICRO OPEN/CLOSED SENSOR
4
2
CONNECTING TO SMARTEE
Getting started
1
2
Page 0
To join the Micro Open/Closed Sensor to the Smartee, make sure you pull the small
plastic tab located at the bottom of the sensor and immediately click on "Add Device" on
your Webee App. The sensor will automatically join the network.
If the sensor does not automatically join the network, remove cover, and remove the
battery. While holding down the reset button, reinsert the battery to factory reset the
device.
If the after following these steps the Micro Open/Closed sensor will not join the Smartee
Zigbee network, do as follows:
•Make sure the Micro Open/Closed sensor batteries are charged.
•Ensure it is within RF range of a Smartee (30-90ft indoor)
Once the Micro Open/Closed sensor is added to your Smartee, you will be able to start
controlling it trough your Webee Apps.
If it becomes necessary to remove the Micro Open/Closed sensor from a Zigbee
network then you must factory reset the Open/Closed sensor. To do it:
A. Remove cover from sensor and remove the battery.
D. Press and hold the reset button while reinserting the battery.
Adding to Zigbee Network
Removing from Zigbee Network
© 2016 Webee LLC, All rights reserved. Webee and the Webee logo are trademarks or registered trademarks of Webee LLC.