Webee Closee Getting Started - page 4
Webee Closee
GETTING STARTED WITH CLOSEE
4
CONNECTING TO SMARTEE
Getting started
© 2014 Webee LLC, All rights reserved. The Webee logo, Boss and Bees are trademarks or registered trademarks of Webee LLC
1
2
Page 0
Connect Button
LED Light
Battery
To join the Closee to the Smartee, click on the “Add Device” function of your App and
the Smartee will automatically connect your Closee to the network. For more detailed
instructions check our Smartee User Manual.
If the Closee does not automatically join the network, press and hold the Closee button.
The Closee will continuously blink as it attempts to join the hub.
Upon a successful joining of the Closee to the ZigBee network of your Smartee, the
status LED will stop blinking.
If the after following these steps the Closee will not join the Smartee Zigbee network, do
as follows:
•Make sure the Closee is powered up.
•Ensure the Closee is within RF range of a routing device.
• Make sure the network on your Smartee is open for joining. Keep in mind that once you
clicked on Add Devices, the network will be open for 60 seconds.
•Check if the Closee hasn’t join another network (light will be static), see the next step to
learn how to remove it from a network in order to add it to a new one.
Once the Closee is added to your Smartee, you will be able to start controlling it trough
your Webee App.
If it becomes necessary to remove the Closee from a Zigbee network then you must
factory default the Closee. To factory default the Closee:
A. Press and hold the press and hold the Connect button while inserting the battery.
D. Release the button when led is lit.
C. The Led will blink blue while attempting to connect to your Smartee.
Adding to Zigbee Network
Removing from Zigbee Network