1. DL manuals
  2. Weber
  3. Grill
  4. 2200 Series
  5. Instructions Manual

Weber 2200 Series Instructions Manual

Other manuals for 2200 Series: Owner's Manual, Owner's Manual, Owner's Manual, Manual
Manual is about: LP Gas Grill

Summary of 2200 Series

  • Page 1

    ® ® warning: do not try to light this appliance without reading "lighting" instructions section of this manual. This gas appliance is designed for outdoor use only. Notice to installer: these instructions must be left with the owner and the owner should keep them for future use. For your safety if y...

  • Page 2: Assembly

    2 step 2 remove packaged parts remove and unpackage warming rack, weber warm-up basket, 2 cooking grates, cardboard box (which contains cookbook and warranty card), 8 short stainless steel flavorizer bars and 5 long stainless steel flavorizer bars. Note - be sure no packaging material is left in the...

  • Page 3

    3 step 3 reinstallation of stainless steel flavorizer bars, cooking grates and warming rack set the long stainless steel flavorizer bars side to side in the lower position of the cooking box, then set the short stainless steel flavorizer bars, front to back in the upper position. Figure 3. Set the c...

  • Page 4

    4 step 5 removal of lp tank note - you must remove tank and it's packaging before lifting grill out of lower carton. 1) loosen tank lock wing nut and turn tank lock up out of the way. Tighten wing nut. Figure 8 (a). 2) lift tank straight up. The cardboard sleeve will come with it, then remove the sl...

  • Page 5

    5 step 7 install lid remove hinge pins and hair pin cotters from back of cooking box. Set the lid in place. Align the hinges at the rear of the barbecue. Insert hinge pins from the outside. Insert hair pin cotters into the small holes in the hinge pins. Figure 10. Remove tape securing the thermomete...

  • Page 6

    Step 12 check that items are secured note - although the following items were factory assembled, check that they have not loosened during shipping and handling. Remove the tape from the manifold bracket. Check that the bracket is securely hooked onto the frame brace and under the manifold at the cen...

  • Page 7

    7 check that the igniter is secure in the frame brace and has not shifted out of the key hole. Figure 15. If it is loose, slide the igniter into the rear of the key hole. Carefully tighten the igniter lock nut with an adjustable wrench or pliers. Check that the tank panel tabs are in their slots in ...

  • Page 8

    8 step 13 connect filled lp tank warning: make sure that the lp tank valve is closed. Close by turning clockwise. Hook the lp tank onto the fuel scale. Loosen the tank lock wing nut. Swing the tank lock down. Tighten the wing nut. Figure 18. F e figure 18 tank lock wing nut remove the tape from the ...

  • Page 9

    9 step 14 check for gas leaks warning: you should check for gas leaks every time you disconnect and reconnect a gas fitting. Note - all factory made connections have been thoroughly checked for gas leaks. The burners have been flame tested. As a safety precaution you should recheck all fittings for ...

  • Page 10

    10 ® ® ® ® ® ® ® ® w ebe r w e be r 1 2 4 5 6 7 8 9 12 10-11 14 15 16, 11 22, 23 25 27 28 29 30 31 32 33 64-65 58 57 8 55 53 52 51 50 49 47 46 45 44 43 42 41 56 11 34 11 39 35 36 37 38 54 48 26 13 24 17 18-19, 11 21 20 10 3 59-63 40 18 19 11 15 13 66 67.

  • Page 11: Parts List

    11 parts list all items are single quantities unless otherwise specified. Parts can be ordered directly from weber-stephen products company by phone or mail. Note - do not return parts to weber-stephen products co. Without first contacting the customer service center by phone or mail. Returning the ...

  • Page 12: A F

    A f inal w ord of t hanks hank you for choosing a weber barbecue. Our family here at weber has worked hard to produce the highest quality products for your satisfaction. While we give much attention to our products, an occasional error may occur. Our knowledgeable customer service staff is prepared ...