Weber 3400 Series Instructions Manual

Other manuals for 3400 Series: Owner's Manual, Operating Manual
Manual is about: LP Gas Barbecue

Summary of 3400 Series

  • Page 1

    Warning: do not try to light this appliance without reading "lighting" instructions section of this manual. This gas appliance is designed for outdoor use only. Notice to installer: these instructions must be left with the owner and the owner should keep them for future use. For your safety if you s...

  • Page 3: Assembly

    3 step 2 remove packaged parts remove and unpackage glass door assemblies, warming rack, weber warm-up basket, 2 cooking grates, corrugated box (which contains cookbook and warranty card), 8 short stainless steel flavorizer bars and 5 long stainless steel flavorizer bars. Figure 2. Note - be sure no...

  • Page 4

    4 step 3 reinstallation of stainless steel flavorizer bars, cooking grates and warming rack set the long stainless steel flavorizer bars side to side in the lower position of the cooking box, then set the short stainless steel flavorizer bars, front to back in the upper position. Figure 4. Set the c...

  • Page 5

    5 step 5 removal of lp tank note - you must remove tank and it's packaging before lifting grill out of lower carton. 1) loosen tank lock wing nut and turn tank lock up out of the way. Tighten wing nut. Figure 9 (a). 2) lift tank straight up. The cardboard sleeve will come with it, then remove the sl...

  • Page 6

    6 step 7 install lid remove hinge pins and hair pin cotters from back of cooking box. Set the lid in place. Align the hinges at the rear of the barbecue. Insert hinge pins from the outside. Insert hair pin cotters into the small holes in the hinge pins. Figure 11. Remove tape securing the thermomete...

  • Page 7

    7 step 10 fill lp tank note - the lp tank manufacturer is responsible for the materials, workmanship and performance of the tank. If the tank has a defect, malfunctions, or you have a question regarding the tank, call the tank manufacturer's customer service center. The phone number is on the warnin...

  • Page 8

    8 step 12 check that items are secured note - although the following items were factory assembled, check that they have not loosened during shipping and handling. Remove the tape from the manifold bracket. Check that the bracket is securely hooked onto the frame brace and under the manifold at the c...

  • Page 9

    9 remove the tape from the hose and regulator. Route the hose so it will not interfere with the scale indicator rod. The hose and regulator are connected in the following manner: slide back the collar of the quick disconnect on the tank valve. Push the male fitting of the regulator into the quick di...

  • Page 10

    10 step 14 check for gas leaks warning: you should check for gas leaks every time you disconnect and reconnect a gas fitting. Note - all factory made connections have been thoroughly checked for gas leaks. The burners have been flame tested. As a safety precaution you should recheck all fittings for...

  • Page 11

    11 step 15 put the control panel back on set the control panel in place over both frame braces. (hold the crossover ignition button up while setting the control panel in place.) place your thumbs over the control panel push-in buttons, and push them into the frame brace until they snap into place. F...

  • Page 12

    12 ® ® ® ® ® ® ® ® w ebe r w e be r 1 2 3 4 5 6 7 8 9 10 12 15-16 18-20 21 24 25 29 30 31 32 33 34 35 37 42 14 65-66 61-64 60 59 58 56 54 55 53 49 52 47 46 45 44 43 2 2 2 3 lh rh rh 11 17 14 22 27 28 36 40 48 41 57 1 39 23 38 26 51 50 13 13 67 68 38.

  • Page 13: Parts List

    13 parts list all items are single quantities unless otherwise specified. Parts can be ordered directly from weber-stephen products company by phone or mail. Note - do not return parts to weber-stephen products co. Without first contacting the customer service center by phone or mail. Returning the ...

  • Page 16

    A f inal w ord of t hanks hank you for choosing a weber barbecue. Our family here at weber has worked hard to produce the highest quality products for your satisfaction. While we give much attention to our products, an occasional error may occur. Our knowledgeable customer service staff is prepared ...