Weber 59751 Owner's Manual - page 31
WWW.WEBER.COM
®
31
TROUBLESHOOTING
PROBLEM
CHECK
SOLUTION
#VSOFSTCVSOXJUIBZFMMPXPSPSBOHFGMBNFJO
DPOKVODUJPOXJUIUIFTNFMMPGHBT
Inspect spider / insect screens for possible obstructions
(blockage of holes).
Clean spider/insect screens. Refer to “ANNUAL
MAINTENANCE.”
4ZNQUPNT
#VSOFSTEPOPUJHOJUF03CVSOFSTIBWFBTNBMM
GMJDLFSJOHGMBNFJOUIF)*QPTJUJPO03CBSCFDVF
UFNQFSBUVSFPOMZSFBDIFTUPJOUIF)*
QPTJUJPO
The excess flow safety device, which is part of the
barbecue to cylinder connection, may have been
activated.
To reset the excess flow safety device, close the LP
tank valve and turn all burner control knobs to the OFF
position. Open the grill lid. Slowly turn the LP tank valve
until it is completely open. Wait at least one minute; then
ignite your grill. Refer to “IGNITION.”
#VSOFSEPFTOPUMJHIU03GMBNFJTMPXJO)*QPTJUJPO
Is LP fuel low or empty?
Refill LP cylinder.
Is fuel hose bent or kinked?
Straighten fuel hose.
Does the outside burner light with a match?
If you can light the outside burner with a match, then
check the ignition system.
#VSOFSEPFTOPUJHOJUFXIFOZPVQVTIUIFJHOJUJPO
CVUUPO
Be sure that there is gas flow to the burners by
attempting to match light your burners. Refer to
“MANUAL IGNITION.”
If match lighting is successful, the problem lies in the
ignition system. Refer to “MAINTENANCE.”
Is there is a fresh battery installed?
Verify that the battery is in good condition and installed
correctly. Refer to “BEFORE USING THE BARBECUE.”
Are the wires connected properly to the ignition module?
Be sure that wires are correctly inserted into terminals on
ignition module. Refer to “MAINTENANCE.”
Is there plastic wrapping around the new battery?
Remove plastic wrapping.
Is burner tube positioned too far away from the igniter
electrode?
Check that the burner tube is positioned correctly to the
igniter electrode. Refer to “MAINTENANCE.”
&YQFSJFODJOHGMBSFVQT
$"65*0/%POPUMJOFUIFDPPLCPY
XJUIBMVNJOVNGPJM
Are you preheating barbecue in the prescribed manner?
All burners on HI for 10 to 15 minutes for preheating.
Are the cooking grates heavily coated with burned-on
grease?
Clean thoroughly. Refer to “CLEANING.”
Is the cookbox dirty and not allowing grease to flow into
catch pan?
Clean cookbox.
#VSOFSGMBNFQBUUFSOJTFSSBUJD03GMBNFJTMPXXIFO
CVSOFSJTPO)*03GMBNFTEPOPUSVOUIFXIPMF
MFOHUIPGUIFCVSOFSUVCF
Are burners clean?
Clean burners. Refer to “MAINTENANCE.”
*OTJEFPGMJEBQQFBSTUPCFiQFFMJOHuSFTFNCMFTQBJOU
QFFMJOH
The inside of the lid is cast aluminum and is not painted.
It cannot “peel.” What you are seeing is baked-on grease
that has turned to carbon and is flaking off.
5)*4*4/05"%&'&$5
Clean thoroughly. Refer to “CLEANING.”
*GQSPCMFNTDBOOPUCFDPSSFDUFECZVTJOHUIFTFNFUIPETQMFBTFDPOUBDUUIF$VTUPNFS4FSWJDF3FQSFTFOUBUJWFJOZPVSBSFBVTJOHUIFDPOUBDUJOGPSNBUJPOPOPVS
XFCTJUF-PHPOUPXXXXFCFSDPN
®
HANDLE LIGHT TROUBLESHOOTING (Q320)
PROBLEM
CHECK
SOLUTION
(SJMM0VU
®
)BOEMF-JHIUEPFTOPUMJHIU
Are the batteries old?
Replace batteries.
Are the batteries installed correctly?
Refer to assembly illustration.
Is the lid in the up position with the power button ON?
Light will activate when lid is open.
Is the Grill Out
®
Handle Light activated?
Press the power button.
*GQSPCMFNTDBOOPUCFDPSSFDUFECZVTJOHUIFTFNFUIPETQMFBTFDPOUBDUUIF$VTUPNFS4FSWJDF3FQSFTFOUBUJWFJOZPVSBSFBVTJOHUIFDPOUBDUJOGPSNBUJPOPOPVS
XFCTJUF-PHPOUPXXXXFCFSDPN
®
To replace batteries, remove lightpod by removing screw
. Push tab and pull apart.
1
2