Weber Genesis 2 Accessory Installation Manual

Genesis

™

Side Burner

Accessory Installation

Step 1

몇

WARNING: All gas controls and supply valves

should be in the OFF position.

You will need: Side burner assembly (includes burner

grate), side burner lock, pipe sealant (suitable for natural

or LP gas), 1/4, 7/16, 5/8, 3/4 and 11/16 inch open-end or

two adjustable wrenches.

Step 2

Genesis 2 and 2000 Models:

Remove the right side work table, burner control knobs

and control panel.

Genesis 4 Models:

Remove the right side work table, serving tray, burner

control knobs, FlameCheck Safety button and control panel.

For use with Genesis Gas Barbecues Only

27-4736910    3/98

Step 3

Note: Your owner’s manual may reflect installing only

one side burner lock. If it does, please ignore and

follow this installation procedure for two side burner

locks.

You will need: frame assembly, two side burner locks and

a 7/16 inch wrench.

Loosen the right rear 1/4 x 20 bolt. Install the side burner

lock. The “U” shape cut out of the lock slips down over the

bolt. Tighten with a wrench. Figure 1 (a).

Loosen the right front 1/4 x 20 bolt. The side burner lock

fits between the front panel and the frame. The “U” shape

cut out slips up over the bolt. Tighten with a wrench.

Figure 1 (b).

Figure 1

(a)

(b)

Follow the remainder of assembly steps in your Owners

Manual.