1. DL manuals
  2. Weber
  3. Grill
  4. PLATINUM 42370
  5. Installation Manual

Weber PLATINUM 42370 Installation Manual

Manual is about: BUILT-IN NG GAS GRILL

Summary of PLATINUM 42370

  • Page 1

    This gas appliance is designed for outdoor use only. 42370 us 10/01/05 ng locating your grill when determining a suitable location for your summit ® gas grill installation, give attention to concerns such as exposure to wind, proximity to traffi c paths, and keeping any gas supply lines as short as ...

  • Page 2

    2 30 1/ 4 " built-in frame 34 1/ 4 " 24" min. 21" access for electric on left hand side 6 1/4 " 3 3/ 4 " gas inlet note: for a countertop treatment: recommended 3/ 4 inch overhang. Notch front edge for frame to fully slide in. 6 1/ 4 " 3 3/ 4 " gas inlet 24" min. 24" min. * clearance from any surfac...

  • Page 3

    3 parts list lid - 1 cookbox - 1 bottom shelf - 1 rear panel assembly- 1 left door - 1 right door - 1 warming rack - 1 warm-up ™ rack - 1 front frame rail - 1 rear frame rail - 1 right enclosure panel - 1 left enclosure panel - 1 front vent panel - 1 lid - 1 cookbox - 1 or rear vent - 1 4b 6b 42370_...

  • Page 4

    4 rotisserie bracket - 1 flavorizor ® bars - 2 sets smoker - 1 stainless steel cooking grates bottom tray - 1 catch-pan holder - 1 catch-pan - 1 disposable drip pans - 2 rotisserie - 1 rotisserie motor - 1 7/16 inch wrench - 1 1/2 inch bolts (1/4 x 20 x 1/2 inch bolt) - 8 hinge pin- 2 hair pin cotte...

  • Page 5

    5 exploded view - platinum d4 48 1 2 5340501 - summit ® platinum d4 ng built-in 091905 17 18 19 21 38 39 40 62 63 64 45 27 42 4 14 20 22 23 24 16 13 57 56 60 3 6 26 65 12 5 7 55 25 15 58 41 43 44 46 47 49 50 51 10 9 8 52 53 54 11 66 68 69 70 76 77 28 29 30 31 33 34 35 67 36 71 72 74 75 61 59 37 73 3...

  • Page 6

    6 exploded view list - platinum d4 1. Hinge pin 2. Thermometer hardware 3. Thermometer bezel 4. Warm-up ™ basket 5. Smoker assembly 6. Flavorizer ® bar assembly w/ smoker 7. Smoker box chip grate 8. Rotisserie motor 9. Motor bracket 10. Motor bracket screw 11. 1/4 - 20 inch keps nut 12. Smoker elect...

  • Page 7

    7 exploded view - platinum d6 8 50 1 2 5390501 - summit ® platinum d6 ng built-in 092005 17 20 21 22 24 42 43 44 58 65 66 67 68 69 47 30 52 9 10 13 12 45 4 6 7 16 23 26 27 28 29 53 55 18 14 15 51 56 60 59 62 57 3 48 49 54 46 19 11 5 25 61 71 72 73 78 79 31 32 33 35 37 38 39 70 40 74 75 76 77 36 41 6...

  • Page 8

    8 exploded view list - platinum d6 1. Hinge pin 2. Thermometer hardware 3. Thermometer bezel 4. Warm-up ™ basket 5. 8 inch cooking grate 6. Smoker assembly 7. Smoker box chip grate 8. Flavorizer ® bar assembly w/ smoker 9. Rotisserie fork 10. Rotisserie motor 11. Motor bracket 12. Motor bracket scre...

  • Page 9

    9 1 1 2 2 3 1 2 attention! Do not fully tighten screws. Clips should slide freely when installed assembly arrow stickers on frame rail (1) and left side panel (2) should point toward each other (shown above). Door stop bracket (3) should be positioned as shown (left). 42370_ng biinstll.Indd 9 9/23/0...

  • Page 10

    10 3 4 assembly 42370_ng biinstll.Indd 10 9/23/05 11:08:26 am.

  • Page 11

    11 5 assembly 42370_ng biinstll.Indd 11 9/23/05 11:08:27 am.

  • Page 12

    12 assembly caution: use two people to lift and install the summit ® built-in frame assembly. A.) lift the frame assembly into the “island” structure opening. Make sure the frame is resting level on the fi nished surface of the structure. B.) adjust the front vent to rest squarely on ground. C.) app...

  • Page 13

    13 7 4b 6b (1) (3) (2) assembly 42370_ng biinstll.Indd 13 9/23/05 11:08:28 am.

  • Page 14

    14 8 (1) (2) 4b 6b assembly 42370_ng biinstll.Indd 14 9/23/05 11:08:28 am.

  • Page 15

    15 match holder a b c 4b 6b 9 assembly 42370_ng biinstll.Indd 15 9/23/05 11:08:29 am.

  • Page 16

    16 10 assembly 11 1/4" drill bit 42370_ng biinstll.Indd 16 9/23/05 11:08:32 am.

  • Page 17

    17 12 13 assembly 14 15 42370_ng biinstll.Indd 17 9/23/05 11:08:32 am.

  • Page 18

    18 6 1/ 4 " 3 3/ 4 " gas inlet b (6 1/ 4 ") a (3 3/ 4 ") c side view plan view left side gas inlet table 10-1 maximum capacity of pipe in cubic feet of gas per hour for gas pressures of 0.5 psi or less and a pressure drop of 0.3 inch water column. (based on a 0.60 specifi c gravity gas) nominal iron...

  • Page 19

    19 gas line piping • refer to the piping chart at the bottom of previous page. • the corrugated gas line from the manifold is 58 inches long. Do not extend the gas line. • we have provided the means to make an sae 45° fl are connection. Do not use pipe sealant on this connection. • if the length of ...

  • Page 20

    20 ventilation warning: air holes must be provided in the structure at the top and bottom to provide ventilation in the event of a gas leak. Air holes can be located in a low visibility area and should be protected by screening material to prevent rodents and insects from entering the structure. Air...