43267 us 08/06/08 lp gas grill built-in lp gas grill installation guide #43267 s-460 ™ s-660 ™ you must read this owner’s guide before operating your gas grill danger if you smell gas: 1. Shut off gas to the appliance. 2. Extinguish any open flames. 3. Open lid. 4. If odor continues, keep away from ...
2 www.Weber.Com ® danger failure to follow the dangers, warnings and cautions contained in this owner’s manual may result in serious bodily injury or death, or in a fire or an explosion causing damage to property. Warnings do not store a spare or disconnected liquid propane cylinder under or near th...
3 www.Weber.Com ® 3 general construction details summit ® built-in unit and all other accessory units should be on site before construction begins. All dimensions have a tolerance of plus or minus (+/-) 1/4 inch (6.35 mm). The grill frame rests directly on the island structure top finished surface. ...
4 www.Weber.Com ® or s-460 ™ s-660 ™ parts list lid - 1 cookbox - 1 lid - 1 cookbox - 1 front frame rail - 1 rear frame rail - 1 rear panel assembly - 1 bottom shelf - 1 left door - 1 right door - 1 warming rack - 1 right enclosure panel - 1 left enclosure panel - 1 front vent panel - 1 rear vent - ...
5 www.Weber.Com ® 5 parts list flavorizer ® bars - 8 - 12 stainless steel cooking grates - 2 - 3 collection tray - 1 catch-pan holder - 1 catch-pan - 1 disposable drip pans - 2 right front vent clip - 1 left front vent clip - 1 rotisserie - 1 rotisserie fork - 4 rotisserie motor - 1 rotisserie brack...
6 www.Weber.Com ® 1 1 2 2 3 1 2 arrow stickers on frame rail (1) and left side panel (2) should point toward each other (shown above). Door stop bracket (3) should be positioned as shown (left). Assembly.
7 www.Weber.Com ® 7 3 attention! Do not fully tighten screws. Clips should slide freely when installed. 4 assembly.
8 www.Weber.Com ® 5 6 back assembly.
9 www.Weber.Com ® 9 7 assembly.
10 www.Weber.Com ® caution: use two people to lift and install the summit ® built-in frame assembly. A) lift the frame assembly into the “island” structure opening. Make sure the frame is resting level on the finished surface of the structure. B) adjust the front vent to rest squarely on ground. 8 c...
11 www.Weber.Com ® 11 9 10 a (1) s-460™ s-660™ a) apply a bead of silicone sealant (1) around the perimeter and front edges of the grill that are in contact with the “island” structure. This will prevent moisture seepage. The sealant you use must have a temperature rating above 120°f (48.8° c). 1/4"...
12 www.Weber.Com ® battery housing wiring 1 black wire 2 green wire 3 red wire 4 red wire warning: make sure that all control knobs are turned to the off position before connecting the gas supply and operating the grill. Assembly f ))# s-460™ 11 3 4 1 2 3 - d.
13 www.Weber.Com ® 13 assembly 13 12 (1) (2) (3) note: secure wire to side panel. Requires 3 “d” alkaline batteries (included). Use alkaline batteries only. Do not mix old and new batteries or different types of batteries (standard, alkaline or rechargeable)..
14 www.Weber.Com ® assembly s-660™ s-460™ 14 16 15 s-660™ s-460™.
15 www.Weber.Com ® 15 s-660™ s-460™ a b c 17 match holder assembly.
16 www.Weber.Com ® 18 1/4" (6.35 mm) drill bit assembly attention! Before drilling any holes for the rear vent make sure the cookbox is flush with the front of the grill frame..
17 www.Weber.Com ® 17 s-660™ s-460™ 19 assembly 20 s-460 ™ s-660 ™.
18 www.Weber.Com ® s-660™ s-460™ 21 22 s-660 ™ s-460 ™ assembly.
19 www.Weber.Com ® 19 assembly 23 s-660™ s-460™.
20 www.Weber.Com ® 24 s-460 ™ s-660 ™ assembly.
21 www.Weber.Com ® 21 s-660 ™ s-460 ™ s-660 ™ s-460 ™ s-660 ™ + aaa + aaa + aaa 25 - 1 - 2 - 2 - 4 the weber grill out ™ handle light has a “tilt sensor”: lid up - on / lid closed - off. The power button (a) activates or deactivates the “tilt sensor.” for daytime use, deactivate the sensor by pressi...
22 www.Weber.Com ® typical bulk propane gas supply installation built-in gas line locations note: leave an access in the “island” structure for gas supply and regulator service that is not inside the grill structure. Note: area should be kept clear of sharp, jagged, or extremely abrasive surfaces to...
23 www.Weber.Com ® 23 table 6.2(a) maximum capacity of metallic pipe in cubic feet of gas per hour for gas pressures of 2 psi or less and a pressure drop of 0.3 inch water column. (based on a 0.60 specific gravity gas) nominal iron pipe size (inches) actual id: (inches) length of pipe (feet) 10 20 3...
24 www.Weber.Com ® typical 20 lp propane gas supply installation gas supply the remote tank enclosure kit provide with you grill shall be used for installations using a 20 lb lp cylinder, mounted in an “island” structure. The remote tank enclosure shall house the included hose and regulator assembly...
25 www.Weber.Com ® 25 operating warning: only use the weber ® tank enclosure kit outdoors in a well-ventilated area. Do not use in a garage, building, breezeway or any other enclosed area. Warning: your weber ® tank enclosure kit shall not be used under an unprotected combustible roof or overhang. W...
26 www.Weber.Com ® locating your lp tank enclosure kit when determining a suitable location for your lp tank enclosure kit installation, give attention to concerns such as proximity to traffic paths, and keeping any gas supply lines as short as possible. Never locate the summit ® lp tank enclosure k...
27 www.Weber.Com ® 27 2 4 8 4 2 4 2 2 parts list hose and regulator - 1 tank stand - 1 tank stand base - 1 tank scale - 1 1/4-20 nut - 6 nylon washer - 12 1/4-20 x 1/2” bolt - 6 cylinder glide - 2 1/2” flare gasket - 2 3/8” flare gasket - 2 parts list / assembly 1.
28 www.Weber.Com ® 3 4 mounting the lp tank bracket mount the lp tank bracket to the right hand side of the enclosure opening using non corrosive hardware. Mounting holes are provided on the sides and bottom of your lp tank bracket. Be sure to mount the bracket securley to the enclosure before use. ...
29 www.Weber.Com ® 29 a b c d e i ii iv v connect gas supply a 58 inch (147.32 cm) corrugated gas line is supplied with the grill. This line needs to pass through the gas inlet opening to the main gas supply. 1) connect the corrugated gas line to the manifold located on the right hand side of grill ...
30 www.Weber.Com ® ventilation warning: ventillation holes must be provided in the structure at the top and bottom to provide ventilation in the event of a gas leak. Ventilation holes can be located in a low visibility area and should be protected by screening material to prevent rodents and insects...
31 31 notes.
©2009 the following trademarks are registered in the name of weber-stephen products co., an illinois corporation, located at 200 east daniels road, palatine, illinois 60067 u.S.A. Australia; smokey joe, weber, kettle silhouette , genesis, austria; kettle silhouette , smokey joe, weber, benelux; kett...
