Weber Summit 43270 Installation Manual

Other manuals for Summit 43270: Installation Manual
Manual is about: Built-In Natural Gas Grill

Summary of Summit 43270

  • Page 1

    43270 us 06/11/09 ng english gas grill built-in natural gas grill installation guide # 43270 s-460 ™ s-660 ™ you must read this owner’s guide before operating your gas grill. Mdanger if you smell gas: 1. Shut off gas to the appliance. 2. Extinguish any open flames. 3. Open lid. 4. If odor continues,...

  • Page 2

    2 www.Weber.Com ® locating your grill when determining a suitable location for your summit ® gas grill installation, give attention to concerns such as exposure to wind, proximity to traffic paths, and keeping any gas supply lines as short as possible. Never locate the summit ® gas grill in a garage...

  • Page 3

    3 3 www.Weber.Com ® built-in cutout dimensions “island” structure configuration options there are many available options for locating the major components of your island structure.Your major components are: 1) the built in grill 2) gas supply enclosure 3) optional side burner accessory the 3 common ...

  • Page 4

    4 www.Weber.Com ® built-in cutout dimensions s-460™ s-660™ di m ensi o ns 1 24 minimum* (610 mm) 24 minimum* (610 mm) 2 4 3/4 (120.65 mm) 4 3/4 (120.65 mm) 3 6 1/4 (158.75 mm) 6 1/4 (158.75 mm) 4 10 1/2 (266.7 mm) minimum 10 1/2 (266.7 mm) minimum 5 23 (584.2 mm) 23 (584.2 mm) 6 34 3/8 (873.13 mm) 3...

  • Page 5

    5 5 www.Weber.Com ® or s-660 ™ s-460 ™ lid - 1 cookbox - 1 lid - 1 cookbox - 1 front frame rail - 1 rear frame rail - 1 rear panel assembly - 1 bottom shelf - 1 left door - 1 right door - 1 warming rack - 1 right enclosure panel - 1 left enclosure panel - 1 front vent panel - 1 rear vent - 1 corruga...

  • Page 6

    6 www.Weber.Com ® s-660 ™ s-460 ™ s-660 ™ s-460 ™ flavorizer ® bars - 8 - 12 stainless steel cooking grates - 2 - 3 collection tray - 1 catch-pan holder - 1 catch-pan - 1 disposable drip pans - 2 right front vent clip - 1 left front vent clip - 1 rotisserie - 1 rotisserie fork - 4 rotisserie motor -...

  • Page 7

    7 7 www.Weber.Com ® assembly a door stop bracket (a) should be positioned as shown. M attention! Do not attach rear support screws and washers until step #6. 1 2.

  • Page 8

    8 www.Weber.Com ® assembly m attention! Do not fully tighten screws. Clips should slide freely when installed. 3 4.

  • Page 9

    9 9 www.Weber.Com ® assembly back 5 6.

  • Page 10

    10 www.Weber.Com ® assembly 7.

  • Page 11

    11 11 www.Weber.Com ® m caution: use two people to lift and install the summit ® built-in frame assembly. A) lift the frame assembly into the “island” structure opening. Make sure the frame is resting level on the finished surface of the structure. B) adjust the front vent to rest squarely on ground...

  • Page 12

    12 www.Weber.Com ® assembly s-460™ s-660™ 1/4" (6.35 mm) drill bit 9 10

  • Page 13

    13 13 www.Weber.Com ® a) apply a bead of silicone sealant (1) around the perimeter and front edges of the grill that are in contact with the “island” structure. This will prevent moisture seepage. The sealant you use must have a temperature rating above 120°f (48.8° c). 1 a m attention! Before apply...

  • Page 14

    14 www.Weber.Com ® assembly s-660™ s-460™ 1 2 3 4 1 2 3 4 3 - d 12 battery housing wiring 1 black wire 2 green wire 3 red wire 4 red wire m warning: make sure that all control knobs are turned to the off position before connecting the gas supply and operating the grill..

  • Page 15

    15 15 www.Weber.Com ® assembly requires 3 “d” alkaline batteries (included). Use alkaline batteries only. Do not mix old and new batteries or different types of batteries (standard, alkaline or rechargeable). Note: secure wire to side panel. 13 14 3 1 2.

  • Page 16

    16 www.Weber.Com ® assembly 1 2 s-460™ s-660™ 3 1 2 15 16 17.

  • Page 17

    17 17 www.Weber.Com ® assembly s-460™ s-660™ c a b match holder 18.

  • Page 18

    18 www.Weber.Com ® assembly s-460™ s-660™ 1/4" (6.35 mm) drill bit m attention! Before drilling any holes for the rear vent make sure the cookbox is flush with the front of the grill frame. 19 20

  • Page 19

    19 19 www.Weber.Com ® assembly s-460™ s-660™ s-460 ™ s-660 ™ s-660 ™ s-460 ™ 21 22 23.

  • Page 20

    20 www.Weber.Com ® assembly s-460™ s-660™ 24.

  • Page 21

    21 21 www.Weber.Com ® assembly 1 2 s-460 ™ s-660 ™ 25.

  • Page 22

    22 www.Weber.Com ® + + aaa + + aaa + + aaa a - 1 - 2 - 2 - 4 the weber grill out ™ handle light has a “tilt sensor”: lid up - on / lid closed - off. The power button (a) activates or deactivates the “tilt sensor.” for daytime use, deactivate the sensor by pressing power button (a). Gas supply requir...

  • Page 23

    23 23 www.Weber.Com ® typical natural gas supply installation we recommend that this installation be done by a licensed professional. General specifications for piping note - contact your local municipality for building codes regulating outdoor gas grill installations. In absence of local codes, you...

  • Page 24

    24 www.Weber.Com ® gas supply 1 1 c c a b d d f f e e 1 2 1 1 connect gas supply a 58 inch (147.32 cm) corrugated gas line is supplied with the grill. This line needs to pass through the gas inlet opening to the main gas supply. 1) connect the corrugated gas line to the regulator (a). Use the 1/2” (...

  • Page 25

    25 25 www.Weber.Com ® gas supply ventilation m warning: ventillation holes must be provided in the structure at the top and bottom to provide ventilation in the event of a gas leak. Ventilation holes can be located in a low visibility area and should be protected by screening material to prevent rod...

  • Page 26

    26 www.Weber.Com ®.

  • Page 27

    Www.Weber.Com ® 27 27.

  • Page 28

    M attention: this product has been safety tested and is only certified for use in a specific country. Refer to country designation located on outer carton. These parts may be gas carrying or gas burning components. Please contact weber-stephen products co., customer service department for genuine we...