Weber Summit 475 Manual

Other manuals for Summit 475: Instructions Manual, Step-by-step Manual

Manual is about: Natural Gas Barbecues

Page of 4

Download

Bookmark us

SUMMIT

™

475 & 675

Built-in Sleeve

97070

12/96

Serial Number

NOTICE TO INSTALLER: These instructions

must be left with the owner and the owner

should keep them for future use.

WARNING: Follow all leak check procedures

carefully in this manual prior to barbecue

operation. Do this even if barbecue was

dealer assembled.

WARNING: Do not try to light this appliance

without reading "Lighting" instructions section

of this manual.

THIS GAS APPLIANCE IS DESIGNED FOR

OUTDOOR USE ONLY.

FOR YOUR SAFETY

If you smell gas:

1. Shut off gas to the appliance.

2. Extinguish any open flame.

3. Open lid.

4. If odor continues, immediately call your

gas supplier or your fire department.

FOR YOUR SAFETY: Do not store or use

gasoline or other flammable vapors and liquids

in the vicinity of this or any other appliance.

Page 1
Summit ™ 475 & 675 built-in sleeve 97070 12/96 serial number notice to installer: these instructions must be left with the owner and the owner should keep them for future use. Warning: follow all leak check procedures carefully in this manual prior to barbecue operation. Do this even if barbecue was...
Page 2: Remove Packaged
Remove packaged parts back panel rail (2) right panel left panel bottom panel assemble back panel to bottom panel assemble left panel to bottom panel 8-7/8 screw (22) front door place the back panel perpendicular to the bottom panel. Insert screws and tighten. Figure 1. Place the left panel perpendi...
Page 3: Assemble Rails to
Assemble rails to left panel assemble right panel to bottom panel assemble back panel to side panels insert the rails into the left panel. Figure 3. Place the right panel perpendicular to the bottom panel. Guide the rails into the right panel. Insert screws and tighten. Figure 4. Insert screws along...
Page 4: Assemble Door to
Assemble door to side panels add two washers on each end of the wire. Insert the bottom wire of the door into the bushing of the left panel. Pull the wire up and in to insert it into the bushing in the right panel. Figure 6. Once the bottom wire is in place, push it down so it snaps into the bottom ...