Weber Summit S-440 Installation Manual

Other manuals for Summit S-440: Owner's Manual

Summary of Summit S-440

  • Page 1

    43165 us 01/30/07 lp gas grill built-in lp gas grill installation guide #43165 s-440 s-640 you must read this owner’s guide before operating your gas grill danger if you smell gas: 1. Shut off gas to the appliance. 2. Extinguish any open fl ames. 3. Open lid. 4. If odor continues, keep away from the...

  • Page 2

    2 www.Weber.Com ® locating your grill when determining a suitable location for your summit ® gas grill installation, give attention to concerns such as exposure to wind, proximity to traffi c paths, and keeping any gas supply lines as short as possible. Never locate the summit ® gas grill in a garag...

  • Page 3

    3 www.Weber.Com ® 3 1 6 7 8 5 3 2 4 a c d b 1 1 1 3 2 b general construction details summit ® built-in unit and all other accessory units should be on site before construction begins. All dimensions have a tolerance of plus or minus (+/-) 1/4 inch (6.35 mm). The grill frame rests directly on the isl...

  • Page 4

    4 www.Weber.Com ® or s-440 s-640 lid - 1 cookbox - 1 lid - 1 cookbox - 1 front frame rail - 1 rear frame rail - 1 rear panel assembly - 1 bottom shelf - 1 left door - 1 right door - 1 warming rack - 1 right enclosure panel - 1 left enclosure panel - 1 front vent panel - 1 rear vent - 1 parts list.

  • Page 5

    5 www.Weber.Com ® 5 s-440 s-640 s-440 s-640 flavorizer® bars - 8 - 12 stainless steel cooking grates - 2 - 3 collection tray - 1 catch-pan holder - 1 catch-pan - 1 disposable drip pans - 2 hinge pin- 2 hair pin cotter- 2 corrugated gas line - 1 right front vent clip - 1 left front vent clip - 1 7/16...

  • Page 6

    6 www.Weber.Com ® 1 1 2 2 3 1 2 arrow stickers on frame rail (1) and left side panel (2) should point toward each other (shown above). Door stop bracket (3) should be positioned as shown (left). Assembly.

  • Page 7

    7 www.Weber.Com ® 7 3 attention! Do not fully tighten screws. Clips should slide freely when installed. 4 assembly.

  • Page 8

    8 www.Weber.Com ® 5 6 back assembly.

  • Page 9

    9 www.Weber.Com ® 9 7 assembly.

  • Page 10

    10 www.Weber.Com ® caution: use two people to lift and install the summit ® built-in frame assembly. A.) lift the frame assembly into the “island” structure opening. Make sure the frame is resting level on the fi nished surface of the structure. B.) adjust the front vent to rest squarely on ground. ...

  • Page 11

    11 www.Weber.Com ® 11 9 10 c . (1) s440 s640 c.) apply a bead of silicone sealant (1) around the perimeter and front edges of the grill that are in contact with the “island” structure. This will prevent moisture seepage. The sealant you use must have a temperature rating above 120°f (48.8° c). 1/4” ...

  • Page 12: (1)

    12 www.Weber.Com ® f)'# s440 11 (1) (3) (2) 12 assembly.

  • Page 13

    13 www.Weber.Com ® 13 s640 s440 13 14 (1) (2) s640 s440 assembly.

  • Page 14

    14 www.Weber.Com ® s640 s440 a b c 15 match holder assembly.

  • Page 15

    15 www.Weber.Com ® 15 s640 s440 16 17 1/4” (6.35 mm) drill bit assembly.

  • Page 16

    16 www.Weber.Com ® s640 s440 18 19 20 s440 s640 s640 s440 assembly.

  • Page 17

    17 www.Weber.Com ® 17 assembly 21 s640 s440

  • Page 18

    18 www.Weber.Com ® (1) (2) (3) 22 s-440 s-640 assembly.

  • Page 19

    19 www.Weber.Com ® 19 + aaa + aaa + aaa a 23 - 1 s-440 s-640 - 2 - 2 s-440 s-640 - 4 s-640 the weber grill out ™ handle light has a “tilt sensor”: lid up - on / lid closed - off. The power button (a) activates or deactivates the “tilt sensor.” for daytime use, deactivate the sensor by pressing power...

  • Page 20

    20 www.Weber.Com ® table 10-1 maximum capacity of pipe in cubic feet of gas per hour for gas pressures of 0.5 psi or less and a pressure drop of 0.3 inch water column. (based on a 0.60 specifi c gravity gas) nominal iron pipe size (inches) internal diameter (inches) length of pipe (feet) 10 20 30 40...

  • Page 21

    21 www.Weber.Com ® 21 gas line piping • refer to the piping chart at the bottom of previous page. • the corrugated gas line from the manifold is 58 inches (1,473.2 mm) long. Do not extend the gas line. • we have provided the means to make an sae 45° fl are connection. Do not use pipe sealant on this...

  • Page 22

    22 www.Weber.Com ® operating warning: only use the weber ® tank enclosure kit outdoors in a well-ventilated area. Do not use in a garage, building, breezeway or any other enclosed area. Warning: your weber ® tank enclosure kit shall not be used under an unprotected combustible roof or overhang. Warn...

  • Page 23

    23 www.Weber.Com ® 23 locating your lp tank enclosure kit when determining a suitable location for your lp tank enclosure kit installation, give attention to concerns such as proximity to traffi c paths, and keeping any gas supply lines as short as possible. Never locate the summit ® lp tank enclosu...

  • Page 24

    24 www.Weber.Com ® 4 8 4 1 2 4 2 2 parts list 2 hose and regulator - 1 tank stand - 1 tank stand base - 1 tank scale - 1 1/4-20 nut - 6 nylon washer - 12 1/4-20 x 1/2” bolt - 6 cylinder glide - 2 1/2” flare gasket - 2 3/8” flare gasket - 2 parts list / assembly.

  • Page 25

    25 www.Weber.Com ® 25 mounting the lp tank bracket mount the lp tank bracket to the right hand side of the enclosure opening using non corrosive hardware. Mounting holes are provided on the sides and bottom of your lp tank bracket. Be sure to mount the bracket securley to the enclosure before use. M...

  • Page 26

    26 www.Weber.Com ® a b c d e i ii iii iv v connect gas supply a 58 inch (1,473.2 mm) corrugated gas line is supplied with the grill. This line needs to pass through the gas inlet opening to the main gas supply. 1) connect the corrugated gas line to the manifold located on the right hand side of gril...

  • Page 27

    27 www.Weber.Com ® 27 ventilation warning: air holes must be provided in the structure at the top and bottom to provide ventilation in the event of a gas leak. Air holes can be located in a low visibility area and should be protected by screening material to prevent rodents and insects from entering...

  • Page 28

    ©2007 the following trademarks are registered in the name of weber-stephen products co., an illinois corporation, located at 200 east daniels road, palatine, illinois 60067 u.S.A. Australia; smokey joe, weber, kettle silhouette ® , genesis, austria; kettle silhouette ® , smokey joe, weber, benelux; ...