WeBoost drive 3G-M User Manual - page 6
6
INSIDE ANTENNA OPTIONS
Slim Low Profile
301152 - w/ 10’ RG174
Low Profile
311106 - w/ 10’ RG58
OUTSIDE ANTENNA OPTIONS
Mini-Mag
301126 w/ 12 5 RG174 cable- SMA
301113 w/ 12 .5 RG174 cable - FME
12” Mag Mount
311125 w/ 12 .5’ RG174
311128 w/ 12 .5’ RG174
314202 w/ 12 .5’ RG174
Trucker Antenna
311101 w/10 5’ RG58
311701 w/10 .5’ RG58
Trucker Antenna
311119 w/13 .5’ RG58
311133 w/13 .5’ RG58
Marine Antenna
311130-5810 w/10 .5’ RG58
Glass Mount
311102 w/14’ RG58
311114 w/14’ RG58
NMO Antenna
Kit 311104-5810
• 800/1900 NMO Antenna
• 10’ RG58 Cable
Kit 311112-5810
• 800/1900 NMO Antenna
• 10’ RG58 Cable
Kit 314203-5810
• 800/900/1900 NMO Antenna
• 10’ RG58 Cable
Kit 311104-17410
• 800/1900 NMO Antenna
• 10’ RG174 Cable Kit 311104-40015
Kit 311112-17410
• 800/1900 NMO Antenna
• 10’ RG174 Cable
Kit 314203-17410
• 800/900/1900 NMO Antenna
• 10’ RG174 Cable
Antenna Kit Options
BEFORE USE
, you MUST REGISTER THIS DEVICE with your wireless provider
and have your provider’s consent . Most wireless providers consent to the use of
signal boosters . Some providers may not consent to the use of this device on their
network . If you are unsure, contact your provider .
You MUST operate this device with approved antennas and cables as specified by
the manufacturer . Antennas MUST be installed at least 20 cm (8 inches) from any
person .
You MUST cease operating this device immediately if requested by the FCC or a
licensed wireless service provider .
WARNING.
E911 location information may not be provided or may be inaccurate
for calls served by using this device .
This is a CONSUMER device.
Safety Guidelines
Warning:
In a wireless installation, do not plug the Signal Booster directly into the cell phone or cellular data card
using an antenna adapter . It will damage the Signal Booster, cell phone or cellular data card .
Warning:
Do not plug in the DC power supply until the Outside and Inside Antenna cables are attached to the
Signal Booster .
Warning:
The Inside Antennas must have a 1 .5 feet of separation distance from all active users .
Warning:
RF Safety: Any antenna used with this device must be located at least 8 inches from all persons .
Warning:
Use only the power supply provided in this package . The power supply must be 6 V DC Output .
This device complies with Part 15 of FCC rules . Operation is subject to two conditions: (1) This device may not cause
harmful interference, and (2) this device must accept any interference received, including interference that may cause
undesired operation . Changes or modifications not expressly approved by weBoost could void the authority to operate this
equipment .
Each Signal Booster is individually tested and factory set to ensure FCC compliance . The Signal Booster cannot be
adjusted without factory reprogramming or disabling the hardware . The Signal Booster will amplify, but not alter incoming
and outgoing signals in order to increase coverage of authorized frequency bands only . If the Signal Booster is not in use
for five minutes, it will reduce gain until a signal is detected . If a detected signal is too high in a frequency band, or if the
Signal Booster detects an oscillation, the Signal Booster will automatically turn the power off on that band . For a detected
oscillation the Signal Booster will automatically resume normal operation after a minimum of 1 minute . After 5 (five) such
automatic restarts, any problematic bands are permanently shut off until the Signal Booster has been manually restarted
by momentarily removing power from the Signal Booster . Noise power, gain, and linearity are maintained by the Signal
Booster’s microprocessor .