WeBoost DRIVE 3G-S Quick Install Manual - page 2
Outside Antenna Installation
Running Antenna Cable
Connect Coax Cables to Drive 3G-S
Connect Power Supply to Drive 3G-S
Connect to Power Supply
Mount Dash Bracket (optional).
Select a location on top of the vehicle to mount the Mini-Mag
Mount Antenna that is:
Run the Outside Antenna cable into the car. The cable is strong
enough that it may be shut in most vehicle doors without damaging
the cable. For a cleaner look, carefully pull down the door seal, run
the cable under the seal, and push the seal back into place. This
method reduces wear on the cable as the door opens and closes.
Connect the cable from the Mini-Mag Mount Antenna to the
connector on the bottom of the Drive 3G-S.
Plug the power adapter into vehicle’s 12V DC power supply. If your
Drive 3G-S is working correctly, the light will be green.
NOTE: If lights are not green on your weBoost booster, please refer
to the full install guide online or contact customer support at
1-866-294-1660 or email at support@weboost.com.
1
2
3
4
5
6
DC Power Adapter
Vehicle’s Power Supply
Dash Mount Bracket
Drive 3G-S
n
Near the center of the vehicle’s
roof.
n
At least 12 inches from any
other antennas.
n
Free of obstructions.
n
At least 6 inches from any
windows (including sunroofs).
Connect the power cable to the connector on the bottom of the
Drive 3G-S.Slide cell phone into cradle (may have to adjust arms in
different slots to fit your cell phone).
Mini-Mag Mount Antenna
Clean the area where the bracket is to be mounted with the alcohol
wipe included. Allow the area to dry. Peel the backing to expose
the adhesive and press the bracket onto the desired location on
the dashboard. Attach the Drive 3G-S by aligning the rectangular
hole on the back with the tab on Mounting Bracket pushing
downward.
Drive 3G-S