WeBoost ego User Manual - ______
CELL PHONE SIGNAL BOOSTER
3
______
Step 1: Place Booster In
Strong Signal Location On or
Near Window Sill
IMPORTANT: This is the most critical step of the installation process because it
will determine the overall performance of the Booster system. Do not connect the
Booster to power until STEP 4.
Having an accurate measurement of signal strength in decibels (dBm) is crucial when
installing your system. Decibels accurately measure the signal strength you are
receiving.
SIGNAL STRENGTH
EXCELLENT
GOOD
FAIR
POOR
DEAD ZONE
3G/1x
(typically voice)
-70dBm
-71 to -85dBm
-86 to -100dBm
-101 to -109dBm
-110dBm
4G/LTE
(typically data)
-90dBm
-91 to -105dBm
-106 to -110dBm
-111 to -119dBm
-120dBm
Turn off your cell phone’s WiFi to ensure you are checking the
cellular connection. The dBm reading will be refreshed every
30-60 seconds.
Want faster results? Once you have a reading, turn on airplane
mode. Wait 15 seconds. Turn off airplane mode. The signal
strength reading is refreshed.
Walk around your home/office taking signal strength readings
until you find the window that has the best reception.
Place your Booster in the area with the strongest cell phone
signal. The LED light, and weBoost logo should be facing into
the room. Note this will need to connect to the Inside Antenna
(Step 5) with the 25’ Cable.
-95
dBm
-90 dBm
-100 dBm
*May Need External Antenna
If you're not able to get a strong cell signal, try using an app like Open Signal to find
the side of your house closest to a cell phone tower and install the booster on that
side of the house.
Booster
Antenna