Websense V10000 G3 Quick start manual
Quick Start Guide
Websense V10000 G3
Web & Email Security Appliance
See the
Rack Installation Instructions
included in the
Sliding Ready Rail kit.
Contact Websense Technical Support if any items are missing.
Bezel (faceplate)
Power Cables (2)
Documentation Disk
Ethernet Cables (4)
Accessory Kit
1
Sliding Ready Rail Kit
2
• Left Ready Rail
• Right Ready Rail
• Velcro Straps (2)
• Rack Installation Instructions
Cable Management Arm Kit
3
• Cable Management Arm
• Static Support Tray
• Status Indicator Cable
• Cable Tie Wraps
• CMA Installation Instructions
Serial Cable
2
1
1. Connect to the appliance via serial port or KVM in order to access the command line interface for
initial configuration.
Serial port settings are: 9600 baud, 8 bits, no parity.
2. Secure power cables using velcro straps and plug power
cables into an appropriate power source.
1
2
1
2
1
2
Serial Connection
KVM Connection
5
Connect Input Device
Rack Appliance
Power on the appliance and check the following indicators:
Contact Websense Technical Support if any indicators are not
illuminated correctly.
Front
• Power button is illuminated.
• Hard drive LEDs are green.
Rear
• Power supply LEDs are green.
• LEDs for connected interfaces (NICs) are green.
• System status indicator (LED left of power supplies) is solid
blue.
6
Power On Appliance
Please refer to the V-Series Appliance
Getting Started
guide for
more details.
Initial Configuration
Appliance Command Line
(firstboot script)
• Configure security mode.
• Configure Appliance Controller interface (C).
Appliance Manager
• Access the Appliance Manager via the Logon Portal.
• Configure NTP servers/system time.
• Configure applicable network interfaces.
Web Mode
TRITON Unified Security Center
• Enter subscription key, update Master Database, configure
Network Agent, and configure policies in TRITON - Web
Security.
• Requires Windows Server 2008 R2.
Content Gateway Manager (proxy)
• Configure user authentication and select protocols.
Email Mode
TRITON Unified Security Center
• Complete configuration wizard, enter subscription key, and
configure policies in TRITON - Email Security. Configure
email DLP policies in TRITON - Data Security.
• Requires Windows Server 2008 R2.
Web and Email Mode
Perform steps above for Web mode followed by Email mode.
If your site does not have a Websense proxy, skip the Content
Gateway Manager configuration.
7
Configuration Overview
Verify Contents
Plan your deployment before setting up the appliance. See the
back of this guide for a deployment overview and reference sheet.
Before you begin...
The appliance supports the following security modes:
3
Determine Security Mode
Based on your subscription and deployment plan, determine the appropriate security mode for this
appliance.
• Web
(Web Security Gateway/Anywhere)
(Email Security Gateway/Anywhere)
• Web and Email
(Email plus Websense Web Security or Web Security Gateway/Anywhere)
1
2
P2
P1
E2
E1
C
N
Connect the appliance interfaces required by the security mode for this appliance.
Cat 5E cables (or
better) are required. Do not use crossover network cables.
Provides access to the Appliance Manager, Content Gateway Manager, and the optional
on-board Web Security console.
4
Connect Network Cables
QSG420-100_RevA
* The P1 interface is not used for Websense Web Security in this mode