Weed Eater 31WG Instruction Manual

Other manuals for 31WG: Instruction Manual, Instruction Manual
Manual is about: Weed Eater Trimmer/Edger Instruction Manual

Summary of 31WG

  • Page 1

    En glish esp a Ñ o l franÇais warning: read and follow all safety rules and operating instructions before using this product. Failure to do so can result in serious injury. Advertencia: lea el manual de instrucciones y siga todas las advertencias e instrucciones de seguridad. El no hacerlo puede res...

  • Page 2

    2 ul classified product notice only the following gasoline powered combination gardening appliance powerhead models and their respective attachments have been classified by underwriters laboratories, inc., in accordance with the applicable safety requirements. Powerhead including trimmer attachment ...

  • Page 3

    3 unit / maintenance safety s disconnect the spark plug before perform- ing maintenance except carburetor adjust- ments. S look for and replace damaged or loose parts before each use. Look for and repair fuel leaks before use. Keep in good working condition. S replace trimmer head parts that are chi...

  • Page 4

    4 edger safety warning: inspect the area to be edged before each use. Remove objects (rocks, broken glass, nails, wire, etc.) which can be thrown by the blade or can wrap around the shaft. S blade rotates momentarily after the trigger is released. The blade can seriously cut you or others. S allow b...

  • Page 5

    5 warning: only use brushcutter at- tachments that provide a metal shield with proboscis nose. Proboscis nose s use only specified blade and make sure it is properly installed and securely fastened. S cut from your left to your right. Cutting on the right side of the shield will throw debris away fr...

  • Page 6

    6 warning: to prevent serious inju- ry, do not use more than one boom extension with a pole pruner attachment. Warning: keep the pruner away from power lines or electrical wires. S only use for pruning limbs or branches up to 4 inches in diameter. S do not operate the unit faster than the speed need...

  • Page 7

    7 assembly warning: if received assembled, repeat all steps to ensure your unit is properly assembled and all fasteners are secure. Examine parts for damage. Do not use dam- aged parts. Note: if you need assistance or find parts missing or damaged, call 1-800-554-6723. It is normal for the fuel filt...

  • Page 8

    8 operation know your trimmer read this instruction manual and safety rules before operating your unit. Compare the illustrations with your unit to familiarize yourself with the location of the various controls and adjustments. Save this manual for future reference. Line limiter blade primer bulb as...

  • Page 9

    9 on/off switch how to start your unit warning: the trimmer head will turn while starting the engine. Avoid any contact with the muffler. A hot muf- fler can cause serious burns. Starting a cold engine (or a warm engine after running out of fuel) starting position muffler choke lever starter handle ...

  • Page 10

    10 if the unit still doesn’t start, refer to troubleshooting table or call 1-800-554-6723. Operating the coupler this model is equipped with a coupler which enables optional attachments to be installed. The optional attachments are: model: edger 1000e . . . . . . . . . . . . . . . . . . . . . . . Cu...

  • Page 11

    11 can cause serious injury. Do not use other materials such as wire, string, rope, etc. Wire can break off during cutting and become a dangerous missile that can cause serious in- jury. Cutting methods use minimum speed and do not crowd the line when cutting around hard objects (rock, gravel, fence...

  • Page 12

    12 maintenance warning: disconnect the spark plug before performing maintenance except for carburetor adjustments. Check for loose fasteners and parts s spark plug boot s air filter s housing screws s assist handle screw s debris shield check for damaged or worn parts contact an authorized service d...

  • Page 13

    13 1. Cut a length of 30 feet of 0.080 ! (2 mm) diameter round weed eater " brand line. Feed line in direction shown on spool. Spool 2. Insert one end of line into center cavity of empty spool. Ensure line will feed into spool in the direction shown on the spool (counterclockwise). 3. Continue feedi...

  • Page 14

    14 fuel stabilizer is an acceptable alternative in minimizing the formation of fuel gum deposits during storage. Add stabilizer to the gasoline in the fuel tank or fuel storage container. Fol- low the mix instructions found on stabilizer container. Run engine at least 5 minutes after adding stabiliz...

  • Page 15

    15 limited warranty electrolux home products, inc., warrants to the original purchaser that each new weed eater " " " " brand gasoline tool or at- tachment is free from defects in material and workmanship and agrees to repair or replace under this warranty any defective gasoline product or attachmen...

  • Page 16

    16 trolux home products, inc., servic- ing center. If you have any questions regard- ing your warranty rights and responsibilities, you should contact your nearest authorized service center or call electrolux home products, inc., at 1--800--554--6723. Warranty period: any warranted part which is not...