1. DL manuals
  2. Weed Eater
  3. Trimmer
  4. 530085739
  5. Operator's Manual

Weed Eater 530085739 Operator's Manual

Summary of 530085739

  • Page 1

    530085739 10/3/97 ht14/ht17/ht19/ht22 frigidaire home products, augusta, ga 30907 wci outdoor products, inc. 530085739 10/03/97 r c r for household use only r trademark warning: read and follow all safety rules and operating instructions before using this product. Failure to do so can result in seri...

  • Page 2

    2 safety rules important safety instructions warning: when using electric hedge trim- mers, basic safety precautions should always be followed to reduce the risk of fire, electric shock, and personal injury. Read all instruc- tions. Be thoroughly familiar with the controls and the proper use of the ...

  • Page 3: Save These Instructions

    3 trimmer. Receptacles are available hav- ing built-in gfci protection and may be used for this measure of safety. S inspect entire unit, including guards, be- fore each use. Have damaged parts re- placed by a qualified service dealer. Make sure all fasteners are in place and securely fastened. S be...

  • Page 4

    4 assembly carton contents hedge trimmer assist handle screw nut examine parts for damage. Do not use damaged parts. Note: if you need assistance or find parts missing or damaged, call 1-800-554-6723. If you receive your unit assembled, check each step to be sure your unit is properly assembled. Fol...

  • Page 5

    5 operating your unit s squeeze switch to operate your unit. To turn off the unit, release the switch. S read important safety instructions be- fore operating. S hedge trimmer is not to be used to cut stems greater than 3/8 inch thick. S when operating the unit, keep the exten- sion cord behind the ...

  • Page 6

    6 service troubleshooting chart trouble cause remedy cutting blades stop under a load or do not move when switch is pressed. S cut at a slower pace. S clean debris from blades. S plug unit into a 120 volt outlet. S turn on breaker. S contact your service dealer. S forcing blade into ma- terial being...