1. DL manuals
  2. Weed Eater
  3. Edger
  4. 530087456
  5. Operator's Manual

Weed Eater 530087456 Operator's Manual

Summary of 530087456

  • Page 1

    R trademark danger: read and follow all safety rules and operating instructions before using this product. Failure to do so can result in serious injury. Peligro: lea el manual del operador y siga todas las advertencias e instruc- ciones de seguridad. El no hacerlo puede resultar en lesiones graves....

  • Page 2

    2 safety rules warning: when using electric edg- ers, basic safety precautions should always be followed to reduce the risk of fire, electric shock, and personal injury. Read all instructions and safety information throughout this manual. Danger: this power tool can be dangerous! This unit can cause...

  • Page 3

    3 d inspect extension cords before each use and replace if damaged. D don’t abuse cord. Never carry unit by the cord or yank extension cord to disconnect unit. D to reduce the possibility of the ex- tension cord disconnecting from the unit during operation, tie the power cord on the unit to the exte...

  • Page 4

    4 was designed. Use the right ap- pliance. Use only for jobs explained in this manual. Maintenance safety d maintain unit with care. Maintain unit according to recommended proce- dures. Follow instructions for chang- ing blades in the service and ad- justments section. Keep blade and blade guard cle...

  • Page 5

    5 minimum wire gauge recommendations volts 25 ft. 50 ft. 100 ft. 120 16 a.W.G.* 16 a.W.G.* *american wire gauge 14 a.W.G.* 150 ft. 12 a.W.G.* secure extension cord to unit: d tie the power plug on the unit to the extension cord as shown. D insert plug into cord socket. Extension cord power plug on u...

  • Page 6

    6 edging----yields precise, close cutting around sidewalks, driveways, patios, etc. Edging beveling----provides a wider cut or trench around sidewalks, driveways, patios, etc. Beveling removes more material and therefore increases motor load. Be careful to cut slowly to avoid motor stalling or overl...

  • Page 7

    7 service and adjustments blade maintenance warning: the blade will spin mo- mentarily after the motor stops. Make sure blade has stopped turning and disconnect unit from the power source before performing work on the blade. Caution: wear protective gloves when handling or performing mainte- nance o...

  • Page 8

    8 troubleshooting chart symptom cause remedy blade stops under a load or does not turn when switch is pressed. S forcing blade into material. S blade guard clogged with debris. S edge guide bent toward blade. S unit unplugged. S fuse blown/circuit breaker off. S worn spring washer. S none of the abo...