1. DL manuals
  2. Weed Eater
  3. Blower
  4. 545117534
  5. Instruction Manual

Weed Eater 545117534 Instruction Manual

Manual is about: Weed Eater Blower Instruction Manual

Summary of 545117534

  • Page 1

    Ebv 200 r trademark warning: read and follow all safety rules and operating instructions before using this product. Failure to do so can result in serious injury. Advertencia: lea el manual de instrucciones y siga todas las advertencias e instrucciones de seguridad. El no hacerlo puede resultar en l...

  • Page 2: Important Warnings And

    2 safety rules important warnings and safety instructions warning: when using electric gardening appliances, basic safety precautions should always be followed to reduce the risk of fire, electric shock, and serious injury. The warnings and safety instructions in this manual must be followed to redu...

  • Page 3: Warning:

    3 still does not fit, contact a qualified electri- cian to install the proper wall outlet. Do not change the equipment plug, extension cord receptacle, or extension cord plug in any way. S to reduce the risk of electrical shock, use extension cords specifically marked as suitable for outdoor applian...

  • Page 4: Save These Instructions

    4 s have all maintenance other than the rec- ommended procedures described in the instruction manual performed by your au- thorized service dealer. S always see your authorized service deal- er to replace a damaged impeller. Parts that are chipped, cracked, broken, or damaged in any other way can fl...

  • Page 5

    5 assembly warning: stop the unit and dis- connect from the power source before opening the inlet cover or attempting to in- sert or remove the inlet restrictor, blower tube, or vacuum tubes. The motor must be stopped and the impeller blades no longer turning to avoid serious injury from the rotatin...

  • Page 6

    6 4. To attach the lower vacuum tube to the upper vacuum tube, first align the arrows on the two tubes. Then, press the two tubes together until the lower tube is securely seated in the upper tube (about 3 inches). Align arrows on upper and lower tubes lower tube upper tube collection bag assembly 1...

  • Page 7

    7 the extension cord used to reach the power source must be: d specifically marked as suitable for out- door use. The cord must be marked with the suffix “w-a” (in canada “w”). D heavy enough to carry full current from the power source to the unit. Otherwise, loss of power and overheating can occur ...

  • Page 8

    8 on/off switch the on/off switch is used to activate the motor. Inlet cover latch the inlet cover latch is used to open and close the inlet cover and to secure the upper vacuum tube to the blower unit. Blower tube the blower tube is designed to direct the flow of air. Inlet restrictor the inlet res...

  • Page 9

    9 maintenance warning: disconnect power source before performing maintenance. General recommendations the warranty on this unit does not cover items that have been subjected to opera- tor abuse or negligence. To receive full value from the warranty, the operator must maintain unit as instructed in t...

  • Page 10

    10 s clean air vents and air inlet of debris. S store your unit and extension cord in a well ventilated area and covered, if pos- sible, to prevent dust and dirt accumula- tion. Do not cover with plastic. Plastic can- not breathe and may cause condensation and eventual rust or corrosion. S check ent...