Weed Eater 545146904 Instruction Manual

Manual is about: Weed Eater Gas Blower Instruction Manual

Summary of 545146904

  • Page 1

    Important manual -- do not throw away manual importante -- no lo descarte manuel important -- À conserver r trademark e n gl is h esp aÑo l f ranÇais weed eater 1030 stevens creek road augusta, ga 30907 warning: read and follow all safety rules and operating instructions before using this product. F...

  • Page 2

    -- 2 -- identification of safety symbols warning: this unit can be dangerous! Careless or improper use can cause serious injury. Read your operator’s manual carefully until you completely understand and can follow all warnings and safety rules before operating the unit. Failure to do so can result i...

  • Page 3

    -- 3 -- identification of safety symbols warning: fire hazard. Never mix, pour, or store gasoline or use the unit near a flame or sparks (including smoking, open flames, or work that can cause sparks). When using the vacuum attachment, the unit is designed to pick up dry material such as leaves, gra...

  • Page 4

    -- 4 -- d move at least 10 feet (3 meters) away from fuel and fueling site before starting engine. D always store gasoline in a container ap- proved for flammable liquids. Operate your unit safely warning: stop the engine before opening the vacuum inlet door. The engine must be stopped and the impel...

  • Page 5

    -- 5 -- assembly warning: stop engine and be sure the impeller blades have stopped turning be- fore opening the vacuum inlet door or at- tempting to insert or remove the vacuum or blower tubes. The rotating blades can cause serious injury. Always disconnect the spark plug before performing maintenan...

  • Page 6

    -- 6 -- blower tubes. The rotating blades can cause serious injury. 1. Insert the tip of a screwdriver into the latch area of the vacuum inlet. Latch area blower outlet vacuum inlet cover latch area 2. Gently tilt the handle of the screwdriver to- ward the front of the unit to release the latch whil...

  • Page 7

    -- 7 -- operation know your blower read this instruction manual and safety rules before operating your unit. Compare the illustrations with your unit to familiarize yourself with the location of the various controls and adjustments. Save this manual for future reference. Choke lever fuel mix fill ca...

  • Page 8

    -- 8 -- s to reduce noise levels, operate power blowers at the lowest possible throttle speed to do the job. S use rakes and brooms to loosen debris be- fore blowing. S in dusty conditions, slightly dampen sur- faces or use a mister attachment when wa- ter is available. S conserve water by using pow...

  • Page 9

    -- 9 -- choke lever starter handle primer bulb 4. Pull starter rope handle sharply until engine sounds as if it is trying to start, but do not pull rope more than 6 times. 5. As soon as engine sounds as if it is trying to start, move choke lever to half choke position. 6. Pull starter rope sharply u...

  • Page 10

    -- 10 -- clean air filter a dirty air filter decreases engine perform- ance and increases fuel consumption and harmful emissions. Always clean or replace air filter after every 5 hours of operation or yearly, whichever comes first. Air filter cover air filter button cleaning the air filter: 1. Clean...

  • Page 11

    -- 11 -- carburetor idle speed adjustment the carburetor has been carefully set at the factory. Adjustments may be necessary if you notice any of the following conditions: s engine will not idle when the throttle is re- leased. To adjust idle speed: allow engine to idle. Adjust speed until engine ru...

  • Page 12

    -- 12 -- trouble cause remedy engine will not start. 1. Engine flooded. 2. Fuel tank empty. 3. Spark plug not firing. 4. Fuel not reaching carburetor. 5. Compression low. 1. See “starting a flooded engine” in operation section. 2. Fill tank with correct fuel mixture. 3. Install new spark plug. 4. Ch...

  • Page 13

    -- 13 -- limited warranty weed eater , a division of husqvarna con- sumer outdoor products n.A., inc., warrants to the original consumer purchaser that each new weed eater brand gasoline tool or attach- ment is free from defects in material and work- manship and agrees to repair or replace under thi...

  • Page 14

    -- 14 -- failed due to abuse, neglect, improper mainte- nance, unapproved modifications, or the use of parts not made or approved by the original equipment manufacturer. You are responsible for presenting your small off--road engine to an weed eater authorized repair center as soon as a problem exis...