Weed Eater 545186754 Instruction Manual

Manual is about: Weed Eater Blower Instruction Manual

Summary of 545186754

  • Page 1

    Instruction manual manual de instrucciones manuel d’instructions please do not return product to retailer. Por favor, no devuelva el producto al lugar de compra. Veuillez ne pas retourner le produit au détaillant. 1--800--554--6723 www.Weedeater.Com register your product online at: registre su produ...

  • Page 2: Important Warnings And

    2 safety rules important warnings and safety instructions warning: when using electric gardening appliances, basic safety precautions should always be followed to reduce the risk of fire, electric shock, and serious injury. The warnings and safety instructions in this manual must be followed to redu...

  • Page 3: Warning:

    3 size to be used depending on the cord length is shown in this manual. See se- lect an extension cord in the as- sembly section). S do not use multiple cords. S keep the extension cord clear of operator and obstacles at all times. S tie cord to cord retainer and connect to recessed plug as shown in...

  • Page 4: Save These Instructions

    4 power source disconnected. Keep vents and tubes free of debris which can accu- mulate and restrict proper air flow. S do not burn, incinerate, or expose this unit to extreme heat. S store the unit unplugged in a high, cool, dry, indoor area out of the reach of chil- dren. S use only recommended at...

  • Page 5

    5 assembly warning: stop the unit and dis- connect from the power source before opening the inlet cover or attempting to in- sert or remove the inlet restrictor, blower tube, or vacuum tubes. The motor must be stopped and the impeller blades no longer turning to avoid serious injury from the rotatin...

  • Page 6

    6 4. To attach the lower vacuum tube to the upper vacuum tube, first align the arrows on the two tubes. Then, press the two tubes together until the lower tube is securely seated in the upper tube (about 3 inches). Align arrows on upper and lower tubes lower tube upper tube collection bag assembly 1...

  • Page 7

    7 the extension cord used to reach the power source must be: d specifically marked as suitable for out- door use. The cord must be marked with the suffix “w”. D heavy enough to carry full current from the power source to the unit. Otherwise, loss of power and overheating can occur causing damage to ...

  • Page 8

    8 blower tube the blower tube is designed to direct the flow of air. Inlet restrictor the inlet restrictor improves the blower function. Tube release button the tube release button secures the blower tube or elbow tube to the blower unit during operation. Also, pressing the tube release button allow...

  • Page 9

    9 check for damaged or worn parts contact your authorized service dealer for replacement of damaged or worn parts. S on/off switch -- ensure switch functions properly by moving the switch to the off position. Make sure motor stops; then re- start motor and continue. S inlet cover -- discontinue use ...

  • Page 10

    10 troubleshooting table symptom cause remedy unit fails to operate. 1. Switch in the off position. 2. Extension cord discon-- nected. 3. Circuit breaker tripped, or fuse blown. 4. Mechanical failure 1. Slide switch to on position. 2. Reconnect extension cord. 3. Reset circuit breaker or fuse. 4. Co...