1. DL manuals
  2. Weed Eater
  3. Blower
  4. BV1650, BV1800, BV1850, BV2000
  5. Instruction Manual

Weed Eater BV1650, BV1800, BV1850, BV2000 Instruction Manual

Summary of BV1650, BV1800, BV1850, BV2000

  • Page 1

    Important manual -- do not throw away manual importante -- no lo descarte manuel important -- À conserver r trademark english esp a Ñ o l franÇais electrolux home products, inc. 250 bobby jones expressway augusta, ga 30907 warning: read and follow all safety rules and operating instructions before u...

  • Page 2

    -- 2 -- safety rules warning: failure to follow all safety rules and precautions can result in serious injury. Know your unit s read your instruction manual carefully until you completely understand and can follow all warnings and safety rules before operat- ing the unit. D restrict unit to users wh...

  • Page 3

    -- 3 -- disconnected. Keep vents and discharge tubes free of debris which can accumulate and restrict proper air flow. D never place any object in the air intake open- ing as this could restrict proper air flow and cause damage to the unit. D never use for spreading chemicals, fertiliz- ers, or othe...

  • Page 4

    -- 4 -- rib groove d insert the elbow tube into the blower outlet. Make sure elbow tube rib is aligned with the blower outlet groove. D turn clamp knob clockwise to tighten. D secure the ends of the shoulder strap by routing the strap through the buckle as shown. Vacuum tube assembly warning: stop e...

  • Page 5

    -- 5 -- s to reduce noise levels, limit the number of pieces of equipment used at any one time. S to reduce noise levels, operate power blowers at the lowest possible throttle speed to do the job. S use rakes and brooms to loosen debris be- fore blowing. S in dusty conditions, slightly dampen sur- f...

  • Page 6

    -- 6 -- note : if engine has not started, pull starter rope 5 more pulls. If engine still does not run, it is probably flooded. Starting a flooded engine s move the choke lever to the run position. S move throttle lever to the position. S pull rope to clear engine of excess fuel. This could require ...

  • Page 7

    -- 7 -- check muffler mounting screws once each year, ensure muffler mounting screws are secure and tightened properly to prevent damage. Cap screws mounting screw holes muffler cover note: the muffler mounting screws are lo- cated behind the cap screws. The cap screws must be removed to access the ...

  • Page 8

    -- 8 -- s see “fueling your unit.” s replace with correct spark plug. S see “carburetor adjustments.” s contact an authorized service dealer. Trouble cause remedy engine will not start. S engine flooded. S fuel tank empty. S spark plug not firing. S fuel not reaching carburetor. S compression low. S...

  • Page 9

    -- 9 -- u.S. Epa/california emission control warranty statement your warranty rights and obliga- tions: the u.S. Environmental protection agency/california air resources board and poulan/weed eater, division of wci outdoor products are pleased to ex- plain the emissions control system warranty on yo...