1. DL manuals
  2. Weed Eater
  3. Trimmer
  4. RTE115C
  5. Instruction Manual

Weed Eater RTE115C Instruction Manual

Other manuals for RTE115C: Instruction Manual, Parts List
Manual is about: Weed Eater Trimmer Instruction Manual

Summary of RTE115C

  • Page 1

    Rte115c r trademark instruction manual manual de instrucciones manuel d’instructions e n gl is h esp aÑ o l f ranÇa is please do not return unit to retailer. Por favor, no devuelva el aparato al lugar de compra. Veuillez ne pas retourner l’outil au détaillant. 1-800-554-6723 www.Weedeater.Com weed e...

  • Page 2

    2 safety rules warning: when using electric gar- dening appliances, basic safety precautions must always be followed to reduce the risk of fire, electric shock, and serious injury. Read and follow all instructions. Safety information on the unit this power unit can be dangerous! Operator is responsi...

  • Page 3

    3 s do not abuse cord. Never carry the unit by the extension cord or yank extension cord to disconnect unit. S use cord retainer to prevent disconnection of extension cord from unit and possible damage to the unit due to plug movement (see attach the extension cord to your trimmer in the operation s...

  • Page 4

    4 assembly warning: if received assembled, review all assembly steps to ensure your unit is properly assembled and all fasteners are secure. Tube assembly wires upper locking sleeve assembly lower locking sleeve assembly 1. Align upper tube groove with triangle on lower locking sleeve assembly. Push...

  • Page 5

    5 opening for front locking tab shield cutting head motor housing 3. Keep front locking tab in the motor housing. Cutting head shield 4. Push shield toward motor housing until rear locking tabs snap into rear notches. An audible snap must be heard. Ensure the cutting head remains free to rotate and ...

  • Page 6

    6 operating instructions use only a voltage supply as specified on your unit. Select an extension cord extension cord gauge chart length of cord gauge 25 ft. (7.5 m) 50 ft. (15 m) 100 ft. (30 m) 18 gauge 16 gauge 16 gauge extension cords are available for this unit. Attach the extension cord to your...

  • Page 7

    7 scalping mowing your trimmer is ideal for mowing in places conventional lawn mowers cannot reach. In the mowing position, keep the line parallel to the ground. Avoid pressing the head into the ground as this can scalp the ground and dam- age the tool. Mowing sweeping the fanning action of the rota...

  • Page 8

    8 refilling the spool with line warning: use only 0.065 inch (1.65 mm) diameter round line. Other sizes and shapes of line will not advance properly and will result in improper cutting head func- tion or can cause serious injury. Do not use other materials such as wire, string, rope, etc. Wire can b...

  • Page 9

    9 trouble cause remedy trimmer head stops under a load or does not turn when switch is pressed. 1. Allow tip of line to do the cutting. 2. Contact your authorized service dealer. 3. Check breaker box. 4. Remove debris. Line does not advance or breaks while cutting. 1. Check line routing. 2. Rewind l...

  • Page 10

    10 limited warranty weed eater , a division of husqvarna out- door products inc., warrants to the original con- sumer purchaser that each new weed eater brand electric or cordless product is free from defects in material and workmanship and agrees to repair or replace under this warranty any defecti...