1. DL manuals
  2. Weed Eater
  3. Trimmer
  4. WE EL-13TNE
  5. Instruction Manual

Weed Eater WE EL-13TNE Instruction Manual

Other manuals for WE EL-13TNE: Parts List
Manual is about: Weed Eater Trimmer Instruction Manual

Summary of WE EL-13TNE

  • Page 1

    We el-13tne trademark instruction manual manual de instrucciones manuel d’instructions e n g lis h si a Ç n a rf l o Ñ ap s e weed eater 7349 statesville road charlotte, nc 28269 weed eater 850 matheson blvd. West mississauga, ontario l5v 0b4 warning: read and follow all safety rules and operating i...

  • Page 2

    2 safety rules warning: when using electric gar- dening appliances, basic safety precautions must always be followed to reduce the risk of fire, electric shock, and serious injury. Read and follow all instructions. Safety information on the unit this power unit can be dangerous! Operator is responsi...

  • Page 3

    3 s do not abuse cord. Never carry the unit by the extension cord or yank extension cord to disconnect unit. S use cord retainer to prevent disconnection of extension cord from unit and possible damage to the unit due to plug movement (see attach the extension cord to your trimmer in the operation s...

  • Page 4

    4 assembly warning: if received assembled, review all assembly steps to ensure your unit is properly assembled and all fasteners are secure. Tube assembly wire protector upper locking sleeve assembly lower locking sleeve assembly 2. Align upper tube groove with triangle on lower locking sleeve assem...

  • Page 5

    5 2. Insert the shield onto the motor housing. Ensure the cutting head remains free to rotate and the line is not caught between the shield and the motor housing (see following illustration). 3. Twist the shield as illustrated until the hole in the shield aligns with the hole in the housings. Make s...

  • Page 6

    6 operating instructions use only a voltage supply as specified on your unit. Select an extension cord extension cord gauge chart length of cord gauge 25 ft. (7.5 m) 50 ft. (15 m) 100 ft. (30 m) 18 gauge 16 gauge 16 gauge extension cords are available for this unit. Attach the extension cord to your...

  • Page 7

    7 sweeping the fanning action of the rotating line can be used for a quick and easy clean up. Keep the line parallel to and above the surfaces being swept and move the tool from side to side. Sweeping scalping mowing your trimmer is ideal for mowing in places conventional lawn mowers cannot reach. I...

  • Page 8

    8 service and adjustments replacing the line 1. Disconnect the unit from the power source. 2. Press and hold in the two cap release latches. 3. Pull cap away from the hub. Cap cap release latch spool hub eyelet 4. Remove old spool. 5. Clean entire surface of hub and spool. 6. Replace with a pre--wou...

  • Page 9

    9 trouble cause remedy trimmer head stops under a load or does not turn when switch is pressed. 1. Allow tip of line to do the cutting. 2. Contact your authorized service dealer. 3. Check breaker box. 4. Remove debris. Line does not advance or breaks while cutting. 1. Check line routing. 2. Rewind l...

  • Page 10

    10 limited warranty weed eater , a division of husqvarna con- sumer outdoor products n.A., inc., warrants to the original consumer purchaser that each new weed eater brand electric or cordless pro- duct is free from defects in material and work- manship and agrees to repair or replace under this war...