Weego 66 Owner's Manual - Smarty Clamps™
8
Read all instructions and safety information (see pages 16-17) prior to
using this product. Improper use of this product will void your warranty
and may result in product damage, excess heat, toxic fumes, fire, and
other unsafe conditions for which Weego is not responsible.
Read vehicle owner’s manual first: it may have specific cautions
and instructions about jumping your engine.
This product is for use on
12V Lead-Acid batteries only! DO NOT use this
product on any other voltage battery, such as 6V, 24V, etc.
DO NOT use
this product on lithium-ion batteries.
Never jump or operate any engine in an enclosed area.
Put your vehicle in
PARK and engage the emergency brake (boats and
powersports vehicles should be put in
NEUTRAL).
TURN OFF ALL ELECTRONICS! – air conditioner, radio, lights, etc.
Remove any devices attached to your Weego 66.
Never leave your Weego 66 connected to your engine’s battery unless
actively jumping.
Always disconnect the
Smarty Clamps™
from your Weego 66 when not
in use.
BEFORE YOU JUMP
JUMP STARTING
13
LIGHTING
Your Weego 66 comes with a 600 lumen
LED flashlight. For those that have no idea
what that means, it’s REALLY intense –
most flashlights are less than 300 lumens!
Power on your Weego 66, then briefly press
and release the flashlight button to initiate
the following sequences:
• 1
st
click: Normal
• 2
nd
click: Strobe
• 3
rd
click: SOS
• 4
th
click: OFF
Your Weego 66 will give you
up to 15 hours of flashlight time and up to 30
hours of strobe & SOS light on a full charge.
Flashlight Button
The given estimates of Weego-to-engine compatibility are conservative: we
base them on a situation in which your vehicle’s battery is dead, and your
Weego is the only battery supplying power to your engine. In reality most
batteries aren’t completely dead – they just don’t have enough juice to turn
over the engine on their own and need a little help from your Weego. Even so,
we keep our estimates modest so that you have a greater chance at
experiencing a successful jump every time.
*Engine sizes are approximate; power requirement will vary for
each vehicle. Variations will occur based on multiple factors including:
•Ambient
temperature & condition of your vehicle’s battery
•
Condition of your engine
•
Temperature of your Weego
•
Charge of your Weego
•
Engine compression ratio
You can also skip directly to the OFF position by
holding down the flashlight button.
9
JUMP STARTING YOUR ENGINE
1.
Ensure your engine is completely OFF.
2.
Securely connect the
Smarty Clamps™
to your
Weego 66, then power ON.
3.
Attach
BLACK clamp to your battery’s negative (-)
terminal, then the
RED
clamp to your battery’s
positive
(+)
terminal. Adjust your
Smarty Clamps™
to achieve MAXIMUM contact with the terminals.
Poor connections will prevent you from starting your
engine! Clear off any dirt or buildup with a wire brush
or a dry towel before connecting your clamps.
4.
Place your Weego 66 in a secure location or
suspend using the provided hook & lanyard so it
won’t fall. Check your
Smarty Clamps™
lights.
5.
When you have a
GREEN
READY light, start your
engine. If the engine doesn’t start, turn off your
vehicle and check your
Smarty Clamps™
lights.
6.
After a successful start, quickly disconnect the
Smarty Clamps™
from your Weego 66.
7.
Detach the
Smarty Clamps™
from the battery.
8.
You’re now good to go - be sure to run your engine
for at least 15 minutes before shutting it off again so
it has time to recharge your battery.
If you are having issues getting your engine started,
see Troubleshooting (pages 11-12) for further
details and assistance.
Connect Clamps
Power ON
Attach
BLACK (-),
Then RED (+)
Connect Clamps
Power ON
Attach
BLACK (-),
Then
RED (+)
Once it Starts,
Disconnect Clamps
from Weego 66
Detach Clamps
From Battery
When You Have
GREEN Light,
Start Your Engine
When You Have
GREEN
Light,
Start Your Engine
Once it Starts,
Disconnect Clamps
from Weego 66
Detach Clamps
From Battery
12
The larger the engine, the more power it’s going to need from your Weego to
start; for this reason, we offer a range of sizes to accommodate most engines
so you can choose the model best fit for your vehicle.
Weego Jump Starters can be used on gas and diesel engines* as follows:
•Weego 22s
Gas up to 5L
Diesel up to 2.5L
•Weego 22
Gas up to 5L
Diesel up to 2.5L
•Weego 44
Gas up to 7L
Diesel up to 3.5L
•Weego 66
Gas up to 10L
Diesel up to 5L
NOTE: Extreme cold temperatures effect battery performance. If you operate in
these conditions for any length of time, consider the next-larger Weego.
ENGINE COMPATIBILITY
refer to your vehicle owner’s manual or visit your local service garage to
determine what the issue may be if you are unable to get your vehicle
started even with the help of your Weego 66.
My Weego 66 will not power on:
•The battery needs to be charged. Connect your Weego 66 to the Wall or Car
Charger provided. You will see blinking indicator lights once it begins to charge.
•If Weego 66 will not power on after a jump start, it needs to be connected to a
charger to “reset” – this action only requires a few seconds on the charger.
•Connect Weego 66 to provided Wall Charger
•If on the road, connect Weego 66 to the Car Charger provided – even if your
car battery is low it may still have enough power to reset your Weego 66.
I had my Weego 66 connected to the vehicle battery, and the smart box on
the Smarty Clamps™ initiated a red blinking light sequence, coupled
with an alarm. What’s that about?
•There’s a 3 minute timer on your Smarty Clamps™ that enacts if you
leave the Weego 66 connected to a vehicle battery for too long. The light &
alarm is to remind you that the unit is still connected. Get jumping already!