Weekender eHawkEye Operation Manual - page 5

5

Step 2: Attaching Control Linkages  

Slide the control linkages through the middle hole in the control horns and then slide the locks over the 

end of the linkage as shown above.

Step 2

Step 3: Main Wing Assembly

Slide the wing through the fuselage until prop-

erly positioned. 

Step 3

While not necessary, you can apply 

a small amount of CA glue to hold 

the pieces permanently in place.

Step 4: Receiver Installation

Using the double sided tape, install the receiver 

into the fuselage and plug the servo and ESC 

leads into the appropriate channels. 

Step 4: Battery Installation

Using the included Velcro strip, install the battery 

into the front of the fuselage.

Step 4

Step 5

Step 5: Cutting the Control Surfaces 

Before flying, you will need to cut the control 

surface so they can move freely. Using a sharp 

razor knife, cut only where indicated with 

dashed lines in the above illustration. 

Step 6