Weems & Plath 4002 Instruction Manual - page 15
1
HiStorY Function
HIST .
When this function is used, the same ZOOM level is used as that for the chart
display.
• Press on the
Press on the
HIST .
button. The chart is displayed and a vertical cursor on the curve
button. The chart is displayed and a vertical cursor on the curve
allows you to see the curve values.
• Use the
Use the
+
-
buttons to move the cursor.
buttons to move the cursor..
+
moves the cursor towards the right..
-
moves the cursor towards the left..
On the upper screen, the information displayed is replaced by the air pres-
sure and time values that correspond to the position of the cursor on
the curve in the complete chart zone. When the cursor passes over a MIN
value or a MAX value, MIN or MAX is displayed on the bottom section
of the upper screen of your ELECTRONIC BAROMETER.
In general: if no button is pushed within 10 seconds, the display returns
if no button is pushed within 10 seconds, the display returns
to the initial display, except during setup and when in SET mode..
otHEr FunctionS
MODE
This button allows you to set up the following functions:
• Backlighting
Backlighting
• Time
Time
• Alarm
Alarm
• Timer
Timer
• Buzzer
Buzzer
• Setup
Setup
Pressing lightly on the button turns the device on and Sets the backlighting..
Backlighting:
If the Electronic Barometer is running on battery power, the device will remain lit
for 20 seconds after the last button is pushed. The Electronic Barometer’s default
setting is OFF. Pressing on the
+
button lets you turn on the backlighting to its first
button lets you turn on the backlighting to its first
intensity level. The number 1 appears next to the level. The Electronic Barometer
has 3 levels of intensity: 1, 2 and 3. Pressing a second time on the
+
button lets
you increase the intensity of the backlighting in real time. The number 0 turns the
backlighting off.
Please Note: Backlighting requires a great deal of energy and thus greatly redu-
ces battery life..
Pressing and holding the button will take you to the other setup parameters..
Time:
This allows you to manually set up the change to DST and back as well as the second
time zone.
+ 1hr : adds 1 hour to the displayed time.
adds 1 hour to the displayed time..
- 1hr : subtracts 1 hour from the displayed time.
subtracts 1 hour from the displayed time..
Dual : is set according to the time difference and allows you to activate
is set according to the time difference and allows you to activate
the subsequent display of local time and the time in the second time zone..