Weewell WTB130 User Manual - Figure 2:
WTB130 USER MANUAL
I
5
Figure 2:
3. Remove the battery cover from the inner
product housing, taking care not to lose
any of the 8 screws. Replace old batter-
ies with new AAA batteries. Be sure to
insert the new batteries with the proper
polarity (+/- orientation). See Figure 3.
4. Ensure that the o-ring (the waterproof-
ring) is properly aligned first, then replace the battery cover using
the 8 screws and tighten. Note: If the o-ring is not aligned into
its groove before replacing the battery cover, water leakage
may occur which may damage the unit beyond repair.
5. Test for correct battery installation by applying a small amount of
moisture to the 3 water sensor buttons. The LCD should turn on and
activate, indicating that the batteries have been sucessfully instal-
led.
6. Reinsert the inner product housing into the thermometer’s outer
skin.