2 2 power connections and keypad operation: the cfw09 quick start guide is a supplement to help get the cfw09 started quickly using the most common installation and configuration options. This cfw09 quick start guide is not meant to replace the cfw09 user’s manual. For detailed instructions, safety ...
3 3 basic wiring: 1. Mount the cfw09 to a flat vertical surface. 2. For three-phase input power connect the incoming power leads to the r, s, and t connections on the power terminal and connect the ground lead to pe on the chassis (refer to figure 1). For single-phase input power connect the power l...
4 4 keypad start/stop (local mode): 5. The inverter should still be powered up with a display of “rdy”. Having completed “oriented start-up”, keypad navigation should now be familiar. Verify parameter p202=0 (type of control = v/f 60hz). This is the factory default value and should already be set to...
5 5 3 wire start/stop (remote mode): parameters: 1. Set di1 to general enable (p263=2). 2. Set di3 to start (p265=14). See note below. 3. Set di4 to stop (p266=14). 4. Set p224=1 (dix) if you want the 3 wire control in local mode. 5. Set p227=1 (dix) if you want the 3 wire control in remote mode. Co...
6 6 parameters example: inverter data (example) line: cfw09 rated current: 9 a rated voltage: 380...480 v model: cfw090009tgz motor data (example) power: 5 hp rated speed: 1730 rpm, 4 pole rated current: 7.9 a rated voltage: 460 v frequency: 60 hz cooling: self-ventilated • the following is a typica...
