Wegener 4600 Quick Start Manual
800032-02 Rev. C
page 4 of 4
Wegener Communications, Inc.
800032-02 Rev. C
page 1 of 4
Wegener Communications, Inc.
Indicators
Eight light-emitting diodes (LEDs) provide status information about your U4600 and its processes:
Indicator
Color and
State
Description
GREEN
constant
Unit has demod and FEC lock on the RF carrier
CARRIER
Off
Unit does not have demod and FEC lock on the RF carrier
GREEN
constant
Unit recognizes a valid transport stream
TRANSPORT
Off
Unit does not recognize a valid transport stream
GREEN
constant
COMPEL control stream received within last two minutes (including keep-alives) while
locked continuously on the current transport stream for >2 minutes
GREEN
flash
Unit has had a verified transport stream for >2 minutes and COMPEL is required but
no valid COMPEL
GREEN
flutter
COMPEL has been addressed to unit within last 5 seconds (excluding keep-alives).
COMPEL
Off
Otherwise. Note that this LED must be OFF when there is no valid Transport stream
OR COMPEL
GREEN
constant
Unit is processing services for delivery.
SERVICES
Off
Unit is not processing services.
YELLOW
constant
One or more warning indications present - usually indicates a problem with the
incoming signal, a minor unit fault, a possible impending failure, or that important
information is available
WARNING
Off
No warning conditions
GREEN
constant
A user cue relay is closed (energized).
GREEN
flutter
During a user relay “pulse” activation on any relay
CUE
Off
All user cue relays are open (de-energized)
RED
constant
One or more current alarm indications
RED blink
An alarm event has occurred in the past and has not been acknowledged and cleared
by the user. Note that the alarm LED may also blink while on.
ALARM
Off
No current alarm condition exists
GREEN
constant
Unit has transport MPEG sync and the stream is not scrambled (in the clear).
Streams that are “clear” are always presumed to be “authorized” -- OR -- Unit is
authorized for current scrambled transport stream (or selected program) and has
transport MPEG sync. When using Wegener CA (’97 Version), being “authorized”
means being addressed with current and valid ciphered keystream messages. In a
PIN system, if the transport stream is scrambled, and the unit has been programmed
with any key other than the null ‘00000’, then it presumes that it is “authorized”.
AUTH
Off
Unit has transport sync, the transport stream is scrambled, and the unit is NOT
authorized. Also OFF if no transport sync.
Technical Support
In the event the unit fails to perform as described, contact Wegener Communications Customer Service by phone at
(770) 814-4057, FAX at (678) 624-0294, or E-mail
service@wegener.com
.
Unity 4600 Digital Media Receiver/Decoder
Quick Start Guide
Introduction
If equipped with a receiver card, the U4600 receives an L-band RF carrier from an
external LNB, demodulates the carrier, and then extracts the MPEG transport
stream. If equipped with an ASI transport card, it decodes the ASI line code and
extracts the resulting transport stream. In both cases, if conditional access has
been applied, the U4600 then descrambles the transport stream (or individual
programs) if authorized. It then supplies that stream to the DVB-ASI output (with
program mapping, if enabled). It also may decompress a selected program to
provide composite video and two stereo-audio outputs. (The compressed audio
formats may be MPEG or Dolby AC-3.)
This guide provides information for setup and initial operation of the U4600.
Additional information may be found in the User's Manual (p/n 800032-01) on the
Wegener web site at
www.wegener.com
(click Support and follow the hyperlinks
to access the Unity 4600 Manual).
In addition to this guide, your box should include:
1. Unity 4600 Digital Media Receiver/Decoder
2. Power cord
3. UL safety sheet
Front and Rear Panel Views
The front and rear (typical) panels of the Unity 4600 are shown in the illustration
at right. The Transport Input and Option Module slots may be populated according
to options ordered.
Environmental Conditions & Physical Specifications
Characteristic
Specification
Use
Indoor
Altitude
Up to 2000 meters
Temperature Range
10
o
C to 50
o
C
Relative Humidity (max.)
80% for temperatures up to 31
o
C decreasing
linearly to 50% relative humidity at 40
o
C.
Weight
10.5 pounds or 4.76 kilograms
Dimensions (H x W x D)
1.75" x 19" x 15" or
44.5 mm x 483 mm x 381 mm
Input Power Rating
90-132Vac or 175-264Vac, 43 Watt, 50/60 Hz
Warranty
All Wegener Communications products are warranted against defective materials
and workmanship for a period of one year after shipment to customer. Wegener
Communications' obligation under this warranty is limited to repairing or, at
Wegener Communications' option, replacing parts, subassemblies, or entire
assemblies. Wegener Communications shall not be liable for any special, indirect,
or consequential damages. This warranty does not cover parts or equipment,
which have been subject to misuse, negligence, or accident by the customer
during use. All shipping costs for warranty repairs shall be prepaid by the
customer. There are no other warranties, express or implied, except as stated herein.
Corporate Office
Wegener
11350 Technology Circle
Duluth, GA 30097
Service Department
Wegener
359 Curie Drive
Alpharetta, GA 30005