Wegener iPump 6420 User Manual - 2.1.

iPump 6420 User’s Manual

www.wegener.com 

800070-01 Rev B 

Chapter 2, Page 24 

2.1. 

Unpacking and Inspection 

Carefully unpack the unit and its ac power cord and inspect for obvious signs of physical 

damage that might have occurred during shipment. Also locate the bag of accessories, including 

special cable pigtails and adaptors.  Any damage claims must be reported to the carrier 

immediately. Be sure to check the package contents carefully for important documents and 

materials. 

Note: Please save the packing materials and original shipping containers in case you must 

later return the unit for repair. Packing these units in other containers in such a way that they are 

damaged will void your warranty. 

2.2. 

Location and Mounting 

The 

iPump 6420 

should be mounted in a standard 19-inch equipment rack. After mounting, 

maintain a clean, dry environment for the unit. 

Precautions 

DANGER 

To avoid damage to this and other equipment, or personal injury, the following items 

should be strictly observed. 

Elevated Operating Ambient 

When equipment is installed in a closed or multi-unit rack assembly, the operating ambient 

temperature of the rack environment may be greater than the room ambient temperature. 

Therefore, consideration should be given to the ambient air temperature within the rack, and 

not just inside the room, when deciding if the maximum recommended ambient operating 

temperature (T

MRA

) is being met. 

Reduced Air Flow 

Equipment should be installed such that airflow required for safe operation of the equipment 

is not compromised. To ensure adequate air flow, the 

iPump 6420 

should be arranged in a 

rack with at least one empty rack unit between it and adjacent equipment and with adequate 

clearance around both side vents. 

Mechanical Loading 

Mounting of the equipment in a rack should be such that a hazardous condition is not 

produced by uneven loading. This unit is moderately heavy, so total rack loading must be 

considered. Also, do not rest any unsupported equipment on your 

iPump 6420

. 

DANGER 

Circuit Overloading 

Consideration should be given to the connection of the equipment to the supply circuit and 

the effect that overloading of circuits could have on overcurrent protection and supply 

wiring. Ensure that the total rack or breaker power consumption does not exceed the limits 

of the ac branch circuit. Appropriate consideration of equipment ratings should be used 

when addressing this concern. 

Reliable Earthing 

Reliable earthing of rack-mounted equipment should be maintained. Particular attention 

should be given to supply connections other than direct connections to the branch circuit 

(use of power strips, chassis ground lugs, etc.). 

WARNING:

 FCC-Mandated Suppression of Radio Frequency Emissions

This is a 

Class A

 product. In a domestic environment this product may cause radio 

interference for which the user may need to take mitigating action.

 If the Ethernet port has a cable connected to it, that cable must be properly shielded 

and grounded to minimize RF emissions that could interfere with nearby equipment.