Wegener Unity RF Switch Installation & Operating Manual

Summary of Unity RF Switch

  • Page 1

    Installation/operation guide unity rf switch option data, drawings, and other material contained herein are proprietary to wegener communications, inc., and may not be reproduced or duplicated in any form without the prior permission of wegener communications, inc. When ordering parts from wegener c...

  • Page 2

    Page 2 800016-13 page 2 of 6 1. Introduction the unity rf switch is a software-controlled, four-input, single-output, l-band switch. It allows network and local control of antenna feed selection as well as other signal parameters. Please read the entire set of instructions before beginning the insta...

  • Page 3

    Page 3 page 3 of 6 800016-13 b. Install the rf switch see figure 1 (page 5) and figure 2 (page 5) of this guide for views of the module and its installation. 1. Remove the block-out plate from the module where the switch is to be installed. These screws and holes will be used to mount the rf switch ...

  • Page 4: * * * Warning * * *

    Page 4 800016-13 page 4 of 6 c. Set rf switch options 1. Set jumpers on the option card to the dotted position. When setting the jumpers, observe that there are three pins on each header. The jumper covers two of these pins and connects them together electrically. In one position pin 2 (center pin) ...

  • Page 5

    Page 5 page 5 of 6 800016-13 figure 1. Typical two-connector-cable installation figure 2. Typical three-connector-cable installation unity4000 mother board p/s front rear module 1 rf switch expansion 1 mounting bracket j1 screws from blockout plate hole used if mounted in module 2 standoffs 3 in eac...

  • Page 6

    Page 6 800016-13 page 6 of 6 service return address service department rma# ________ wegener communications, inc. 359 curie drive alpharetta, ga 30005 service contact numbers and addresses voice: (770) 814-4057 fax: (678) 624-0294 email: service@wegener.Com.