Wegener UNITY500 Installation & Quick Start Manual
Page 1 of 4
800010 Rev. A – Printed in USA
UNITY500 - Installation Quick Start Guide
The UNITY500 is a digital satellite receiver that will receive signals from both C and Ku band satellite systems.
Your box should include:
1. The UNITY500 Satellite Receiver
2. This one-page installation guide
3. UL Safety Sheet
4. Power cord
A full user manual is available on-line.
For more information and detailed instructions, visit http://www.wegener.com.
Rear Panel Connections
The UNITY500 rear panel connections are shown and described below.
UNITY500 Rear Panel
UNITY500 Rear Panel With Smart Card Slot And Ethernet Connector
UNITY500 Interconnections
SIGNAL
CONNECTOR
DESCRIPTION
RF IN
F
950 to 2150 MHz signal accepted. LNB power available.
RF SWITCH IN
(Optional)
F (4 Inputs)
950 to 2150 MHz signal accepted. NO LNB power available.
RF SWITCH OUT
F
1-of-4 RF inputs selected, Connects to RF IN.
MAIN VIDEO OUT
RCA Phono Jack
NTSC or PAL, Composite video at 1Vp-p into 75 ohm Load
MONITO-VIDEO OUT
RCA Phono Jack
NTSC or PAL, Composite video at 1Vp-p into 75 ohm Load
AUDIO OUT (R & L)
Two RCA Phono
jacks
Stereo Audio, ~6.18 vp-p into 10k ohm Load
RS232 PORT
RJ-12
Serial Asynchronous Data. May be used for terminal, printer, or modem
(to remote terminal).
MODULE
RF IN
123456
S/N
AUDIO
R
L
OUT
OUT
OUT
MAIN
VIDEO
MONITOR
OUT
RS232
1 6
115/230VAC
50/60Hz
0.8/0.5A
RISQUE DE CHOC ELECTRIQUE NE PAS OUVRIR
RISK OF ELECTRIC SHOCK
AVIS:
DO NOT OPEN
MODULE
RF IN
123456
S/N
AUDIO
R
L
OUT
OUT
OUT
MAIN
VIDEO
MONITOR
OUT
RS232
1 6
115/230VAC
50/60Hz
0.8/0.5A
1 8
10/100
BASE T
SMART CARD
RISQUE DE CHOC ELECTRIQUE NE PAS OUVRIR
RISK OF ELECTRIC SHOCK
AVIS:
DO NOT OPEN
* * * CAUTION * * *
DO NOT CONNECT RJ-12 DIRECTLY TO PHONE LINE.
EQUIPMENT DAMAGE MAY RESULT.