1. DL manuals
  2. Weider
  3. Home Gym
  4. 8630 WEEVSY52000
  5. User Manual

Weider 8630 WEEVSY52000 User Manual

Manual is about: Training System

Summary of 8630 WEEVSY52000

  • Page 1

    User's manual ® model no. Weevsy52000 serial no. Write the serial number in the space above for future reference. Caution read all precautions and instruc- tions in this manual before using this equipment. Save this manual for future reference. Part no. 170831 r0101a printed in canada © 2001 icon he...

  • Page 2

    27 2 table of contents important precautions . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 before you begin . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . ...

  • Page 3

    3 warning: to reduce the risk of serious injury, read the following important precautions before using the training system. Important precautions 1. It is the responsibility of the owner to ensure that all users of the training system are ade- quately informed of all precautions. 2. Read all instruc...

  • Page 4

    Trouble-shooting and maintenance inspect and tighten all parts each time you use the training system. Replace any worn parts immediately. The training system can be cleaned using a damp cloth and mild non-abrasive detergent. Do not use solvents. Tightening the cables woven cable, the type of cable u...

  • Page 5

    5 assembly 24 weight press butterfly leg high low leg ab arm arm lever pulley pulley press pulley plates (lbs.) (lbs.) (lbs.) (lbs.) (lbs.) (lbs.) (lbs.) top 27 20 9 10 10 52 10 1 53 37 18 24 24 94 25 2 79 50 33 40 41 141 40 3 101 65 38 53 53 180 53 4 125 83 48 66 63 228 68 5 148 103 58 80 80 263 83...

  • Page 6

    1. Locate and open the parts bags labeled “frame assembly bag one” and “frame assembly bag two.” press two 2” square outer caps (58) onto the weight base (14) in the indicated locations. Press a 2” square inner cap (56) into the end of the weight base. Insert four 5/16” x 2 1/2” carriage bolts (49) ...

  • Page 7

    4. Slide the front seat frame (8) onto the indi- cated 5/16” x 2 1/2” carriage bolts (49) in the press base (13). Hand tighten two 5/16” nylon locknuts (40) onto the carriage bolts. Attach the other end of the front seat frame (8) to the leg press upright (4) with two 5/16” x 2 3/4” bolts (55), two ...

  • Page 8

    56 57 58 sea t assembl y misc. 8. Lubricate the insides of the holes in the top weights (24) as shown. Slide a top weight onto each set of weight guides (23). 9. Attach the top frame (2) to the ab upright (1) with two 5/16” x 2 3/4” bolts (55), two 5/16” washers (20), and two 5/16” nylon locknuts (4...

  • Page 9

    11. Attach the leg press plate (11) to the adjustment tube (10) with a 5/16” x 2 1/4” bolt (62), two 5/16” washers (20), and a 5/16” nylon locknut (40). Be sure that the leg press plate and adjustment tube are ori- ented as shown. Press a 1 3/4” square inner cap (48) into the adjustment tube (10). 1...

  • Page 10

    19 48. Wrap the low cable (86) around a 3 1/2” pulley (82). Attach the pulley, a set of pulley covers (94), and a 3/8” washer (38) to the ab upright (1) with the 3/8” x 3 3/4” bolt (76) and a 3/8” nylon jam nut (43). Be sure that the cable trap is in the indicated position. 49. Wrap the low cable (8...

  • Page 11

    11 18. Press a 1 3/4” square inner cap (48) into the lower end of the left butterfly arm (6). Wet the lower end of the left butterfly arm with soapy water and slide a 10” pad (22) onto it. Repeat this step with the right butterfly arm (5). 19. Locate and open the parts bags labeled “cable assembly” ...

  • Page 12

    17 40. Note: the 3 1/2” pulley (82) used in this step was attached in step 38. It is shown removed for easier part identification. Route the press cable (88) around the 3 1/2” pulley (82). Be sure that the cable trap (80) is turned to hold the cable in place and that the cable is routed as shown. Ti...

  • Page 13

    13 25. Identify the rear cable (87)—this is the shortest cable. Slide one end of the rear cable onto the 5/16” x 3” bolt (92). Thread another 5/16” nylon jam nut (91) onto the bolt, but do not fully tighten it. Leave enough room between the two jam nuts for the cable to pivot. 26. See the inset draw...

  • Page 14

    15 32. Route the press cable (88) around a 3 1/2” pulley (82). Attache the pulley and a set of pulley covers (94) to the lowest set of holes in the pulley plates (31) with a 3/8” x 2” bolt (50) and a 3/8” nylon locknut (42). The cable must be routed from the direction shown. Be sure that the small t...

  • Page 15

    Note: assembly is divided into four stages: 1) frame assembly, 2) arm assembly, 3) cable assembly, and 4) seat assembly. The hardware for each stage is packaged separately. Wait until you begin each assembly stage to open the parts bag labeled for that assembly stage. This chart is provided to help ...

  • Page 16

    3/8" nylon jam nut(43) 5/16" x 2" carriage bolt (79) cable clip (33) 5/16" x 1 3/4" bolt (68) 3/8" x 2" bolt (50) 5/16" x 2 1/4" bolt (62) 5/16" x 2 1/2" bolt (39) 3/8" x 2 1/2" bolt (65)–1 5/16" x 2 3/4" bolt (55) 5/16" x 3" bolt (92) 3/8" x 3 1/4" bolt (71) 3/8" x 3 1/2" bolt (66) 1/4" washer (37)...

  • Page 17

    81 part list—model no. Weevsy52000 r0101a note: “#” indicates a non-illustrated part. Specifications are subject to change without notice. Key no. Qty. Description 1 1 ab upright 2 1 top frame 3 1 butterfly frame 4 1 leg press upright 5 1 right butterfly arm 6 1 left butterfly arm 7 2 press arm 8 1 ...

  • Page 18

    1 2 3 4 5 6 7 7 8 9 10 11 12 13 14 15 16 17 18 19 17 21 21 22 22 23 23 24 24 25 25 26 26 28 28 29 29 29 29 30 31 32 32 33 34 35 36 21 21 85 85 87 86 31 41 41 86 87 88 88 89 89 56 66 82 38 43 20 55 55 66 50 38 40 20 56 42 82 80 43 42 50 40 69 40 69 67 67 40 68 37 44 40 37 68 44 67 40 40 67 42 50 82 5...

  • Page 19

    3 4 5 7 12 13 14 19 21 22 23 23 24 24 25 25 26 26 32 32 33 34 35 36 21 21 85 87 31 88 89 89 56 82 80 43 42 50 40 69 40 69 67 67 40 68 37 44 40 37 68 44 67 40 40 67 42 55 20 55 20 49 58 83 43 40 20 55 20 76 82 43 43 98 40 37 64 82 42 50 50 37 64 40 82 80 50 42 42 82 80 50 40 56 55 92 95 20 55 56 91 9...