Airflame excel mk.3 remote control af 16nv rc 9500370 ac 16nv rc 9500371 af 16xl rc 9500372 ac 16xl rc 9500373 user manual patent applied for 9860378/03 please leave these instructions with the user this appliance is for use in the united kingdom (gb) and the republic of ireland (ie) only..
2 please note 1. The wonderfire airflame excel is to be used only with the type of gas for which it was supplied. Never attempt to use the appliance with other gas types. 2. Always use a fireguard complying with bs6539 or bs6778 for the protection of the young, elderly, or infirm. 3. The fire is lit...
3 ventilation requirements note: see convector instructions if being installed within a wonderfire convector box for ventilation requirements. Gb a permanent ventilation grille of fixed design and having a minimum free area of 100cm 2 must be fitted with direct access to outside air to room. Ie vent...
4 operation of the fire – continued this position (keeping it depressed) for ten seconds to allow the flame supervision device to establish. Observe if it is alight by looking through the slots to the left hand end of the front coals. If the pilot does not light immediately, repeat the above procedu...
5 figure 5 figure 6 please note: we do not recommend pointing the remote control handset at any domestic animal or operating the device within one meter of the animal’s ear. Research has shown that a domestic cat or dog will not suffer any pain or hearing damage but the ultrasonic transmission signa...
6 for fires fitted with aeration control to operate the aeration control system, the following procedure should be followed: • allow the appliance to warm up, (for at least fifteen minutes) in the fully aerated position, with the control lever pushed in to the locked position – see figure 7, also se...
7 placing the fuel matrix position fuel matrix on top of the burner as shown in figure 9. The rear face of the burner should locate into two cut-outs on the top face of the rear legs. Ensure that the matrix sits flatly on the top of the burner. Placing the dress coals the dress coals consist of: • 2...
8 placing the dress coals – continued next, take both finger coals and place one at each end of the front row of coals as shown in figure 12, again making sure that they bridge across from the front coal to the matrix. Now take six random shaped coals and position as shown in figure 13. This second ...
9 finally, take the three remaining square coals and position at the back of the matrix as shown in figure 14a. These coals should also overlap the previous row by 5-10mm and also, even spacing is once again important. Spare parts the ceramic fuel bed items are customer replaceable. When ordering pl...
10 legal requirement every gas appliance should be installed by a competent person. If in doubt always use the services of a corgi registered installer. Please fill in the following information for your own future reference. This information should always be quoted in any correspondence with your or...
