1. DL manuals
  2. Wood Pellet
  3. Patio Heater
  4. WPPH001.3
  5. Owner's Manual

Wood Pellet WPPH001.3 Owner's Manual

Summary of WPPH001.3

  • Page 1

    Owner’s manual wood pellet patio heater model: wpph001.3 important your safety is very important, please read this manual thoroughly before you install, operate and maintain this heater. Retain this manual for future reference. If you have questions about assembly, operation, servicing or repair of ...

  • Page 2

    Table of contents important warning s……………………………………………………… …………2 introduction………………………………………………………………………….3 specification………………………………………………………………………...3 important safety prec autions…………………………………………….…… .3 assembly…………………………………………………………………………....4 unpackin g…………………………………………………………..………………4 installati...

  • Page 3

    Introduction thank you for choosing the wood pellet patio heater. Please take the time to read these instructions and follow each step carefully for safe operation. Retain this manual for future reference. If you have any question regarding these instructions or operation of this heater, please cont...

  • Page 4

    Do not move or touch the heater while it is hot or burning. do not alter or modify the heater in any manner always keep at least a 36 ‘’ clearance from the stove to any combustible material. do not use the heater if the wind velocity is greater than 10 miles per hour. do not spray aerosols nea...

  • Page 5

    Find and identify the following parts:.

  • Page 6

    Also included in the box is a hardware bag that contains: ¼” bolts (for (m) door to (l) door mounting bracket) ¼” nuts ( for (v) screw in feet, for securing (q) ash pan handles and hopper handles (not pictured) ¼” washer ( for (v) screw in feet) ¼” lock washers (for (q) ash pan handle and hopper han...

  • Page 7

    Ash pan. You will see three zerts in the front of the (j) firebox bottom. This side goes on the same side as the door opening in the front of the heater. The (j) firebox bottom is installed just underneath the damper inlet holes. The ½” flanges on the (j) firebox bottom face down. Step 6 installing ...

  • Page 8

    Step 15 attaching the top to the stove pipe. Place (x) stove pipe spark arrestor onto the top of the second (w) stove pipe section. Secure together using three sheet metal self-taping screws. Space screws out around pipe. 2. Installation this heater is intended to be used outdoors only! It should ne...

  • Page 9

    4. Storage 4.1 when you are finished using the heater you should make sure that the fire is completely out. Allow at least 45 minutes for the heater to cool down before transporting. 4.2 store the heater upright in a sheltered area away from inclement weather such as rain, snow and dust. 4.3 this un...

  • Page 10

    8.5 each of the manufacturer, distributor and retailer will not be liable for any incidental or consequential loss or damage arising from the installation or operation for the product and / or the failure of any part for any reason. 8.6 there are no other express or implied warranties, except for th...