1. DL manuals
  2. Woodhaven
  3. Tools
  4. 3210
  5. Owner's Manual

Woodhaven 3210 Owner's Manual

Summary of 3210

  • Page 1

    Parts list: please identify and verify that you have all of the hardware shown below prior to assembly. Parts listed below are not shown in the hardware drawings. Refer to photos in the instructions: part description quantity 3210a 15-7/8” one track . . . . . . . . . . . . . . . . . 1 3210b 5-5/8” s...

  • Page 2

    Before beginning identify and verify that you have all the parts listed. Read the instructions at least once, familiarizing yourself with the parts before beginning. You'll need a #2 phillips screwdriver for assembly. The small oval jig is designed to be used with a stationary belt or disk sander to...

  • Page 3

    8 2 both pivots should be tightened in the one track, but still be able to pivot on the screw. The size of the oval is controlled by the distance from the tool to the pivots. Coarse adjustments in oval sizes should be set by moving both pivots to the approximate dimensions needed. The 6" one track i...

  • Page 4

    If the part is smaller than the axis base, you will cut into the axis base. We make them out of mdf so this is possible to do without harming the sander or other cutting tool. They are a wear item and will eventually need to be replaced. Order extra axis bases as needed. You can also make your own c...