User manual / instrucciones de usuario equipson, s.A. Www.Equipson.Es support@equipson.Es pa 50 mic1 mic2 phono / aux master volume -10 +10 min max -10 +10 min max 1khz 0 150khz 0 6khz 0 -10 +10 frequency equalizer 10 11 9 12 8 3 1 7 14 6 15 5 6 4 1 17 3 2 18 1 19 0 2 0 power pa 50 ca two series pub...
General description: for the convenience of the users, the ac mains of the amplifier series is controlled by the power selector, it provide the two kinds of voltages: 110v-120v / 220v-240v for greater operational flexibility, two microphones can be in- serted in the amplifier, on which also have "au...
This broadcast system, main unit should be placed on a solid handling this unit don't disassemble this unit --2-- the plug of power line for this unit should be pulled out from power outlet to cut down the power supply, when this unit isn't used for a long period. Moist place; under direct radiation...
Name of functions specifications: microphone sensitivity: -55db 2db aux.Cd sensitivity: -20db 2db output power : 30w at 4 w load frequency responses : 100hz-18khz 3db distortion : less than 1% (at 1khz 1watts output) signal/noise ratio : more than-55db hum or noise level : 50mv tone control response...
--4-- com priority 100v 4 w 8 w 16 w mute control (priority) when the terminals are short circuit, it will be shut down mic2 , aux and phono, mic1 is priority output. Mic1 mic2 phono / aux master volume -10 +10 min max -10 +10 min max 1khz 0 150khz 0 6khz 0 -10 +10 frequency equalizer 10 11 9 12 8 3...
--5-- input connection microphones three microphone inputs are provided. They used with unbalanced low impedance (30~600 ohms) microphoe. The microphone with the unbalanced connection cable of 10-20m may be used depending on the microphone and its characteristic. Mic-1, mic-2 there two microphone in...
--6-- speaker output the amplifier may be used in conjunction with a speaker rated at4, 8, 16 ohms or with 100-volt constant-voltage speaker systems. Low impedance speaker output : 4, 8, 16 ohm (balanced) the low impedance 4, 8, 16 ohm terminal is provided for connection of a few large-output speake...
8w 8w 100v com com 4 w 4 w impedancia total 16 w total impedance 100v 8 w 8 w 16 w 16 w 100v 100v 100 volts speaker output (balanced) when it is desired to operate the speakers from the distance, over 50 meters of the amplifier, it is recom- mended that line matching transformers be installed on the...
1 2 3 v r 1 a 5 0 k v r 2 a 5 0 k v r 3 a 5 0 k 11 22 33 l r l r r 5 8 5 6 k r 6 1 1 0 k r 6 0 2 7 k r 1 3 5 .6 k r 1 4 5 .6 k r 1 6 2 .2 k r 1 7 2 .2 k r 1 5 1 0 k r 2 0 2 7 0 r 1 9 1 0 0 k r 2 4 3 3 0 k r 2 5 5 .6 k r 2 2 1 8 k r 2 3 3 9 0 k r 2 0 2 7 0 r 2 1 6 8 0 c 1 8 4 7 0 p c 1 7 1 0 0 p c 1 ...
