Workhorse ATV 2522 Assembly / Operation Instructions / Parts

Summary of ATV 2522

  • Page 1

    — general information — warranty / parts / service warning: some chemicals will damage the pump valves if allowed to soak untreated for a long period of time. Always flush the pump with water after use. Do not allow chemicals to sit in pump for extended times of idleness. Follow chemical manufacture...

  • Page 2

    — operation — calibration — after spraying — winter storage — tip chart tip spray pressure capacity tip spray pressure capacity tip spray pressure capacity gallons per acre - based on water no. Height (psi) (gpm) no. Height (psi) (gpm) no. Height (psi) (gpm) 1 mph 2 mph 3 mph 4 mph 5 mph 7.5 mph 10 ...

  • Page 3: Instruction #1

    4 5 1 6 2 8 11 12 13 3 14 7 9 10 instruction #1 deluxe spot sprayer instructions: 3.0 --install gauge (item 5) in fitting as illustrated using a good grade thread sealant to prevent leaks. 3.1 --insert lead wire assembly (item 14) into plug at rear of pump. 3.2 --join the red wire of the two-wire ca...

  • Page 4

    Precision spray equipment, a divison of green leaf, inc. 9490 n baldwin st fontanet, in 47851 www.Grnleafinc.Com a division of green leaf, inc ® p r e c i s i o n s p r ay e q u i p m e n t pse 13 boom kit assembly: parts list description stock # qty item 1/4" u-bolt with nuts 600169 2 1 spray boom ...

  • Page 5

    The ratchet straps provided are specifically design to attach a spot sprayer to the rear rack of most common atv’s. Please refer to the following illustrations for proper mounting instructions. Caution: always check the atv load rating before using the sprayer. Excessive weight may cause your atv to...

  • Page 6: — Pump & Valve Assembly

    4 6 8 3 5 10 9 to s pr ay w an d 1 11 2 7 attach spray boom hose assembly here to order replacement parts: 1-800-654-9808 parts list description part number qty item y-garden hose valve 600122 1 1 suction hose 600155 1 2 gauge 0-100 psi 600129 1 3 18.5 mm dia. Pinch clamp 600149 2 4 n3400 p fitting ...

  • Page 7: Powerflo

    Powerflo ™ 7800 series 12 volt dc motor-driven diaphragm pumps specifications — motor: type: 12 vdc, permanent magnet, totally enclosed, non-ventilated leads: 18 awg, 12” long duty cycle: see heat rise graph temperature limits: motor is not equipped with thermal protection. For user safety, optimal ...

  • Page 8

    Troubleshooting guide — problem/causes and remedies: pump will not start check: • correct voltage (±10%) and electrical connections • fuse or breaker • pressure switch operation and correct voltage at switch • rectifier or motor for open or grounded circuit • locked drive assembly pump will not prim...