Workrite Premium Assembly instructions - "44&.#-:*/4536$5*0/4
1450 Technology Lane • Petaluma, CA 94954 • 800-959-9675 • www.workriteergo.com
Page 3
1500068 • Rev. B
Sonoma Series
™
PREMIUM Workcenters
5FDIOPMPHZ-BOFt1FUBMVNB $"ttXXXXSFBDPN
1BHF
"44&.#-:*/4536$5*0/4
Remove and discard Phillips
head transit screws from
sheet metal plates at both
ends of leg assembly.
Attach 5PQ#SBDLFU to
smallest end of each
leg assembly using
3/4” button head
machine screws.
This end is up and
attaches to the underside
of the worksurface.
/PUF if table has three
legs, the center leg uses
the TIPSU5PQ#SBDLFU.
Remove nuts and
lock washers from leg
studs. *GMFHUBCMF, Slide
4UJòFOJOH#SBDLFU onto
studs, slide $SPTTCBS#SBDLFU
onto studs and reinstall nuts
(no lock washers). /PUFIPX
UIFøBOHFPSJFOUTUPUIFMFH
/PUF if table has three
legs, the center leg uses
the EPVCMFøBOHF $SPTTCBS
#SBDLFU. The two Acorn nuts
should be used with this bracket.
Insert 'PPU$BQT into
ends of foot. Screw in
Leveling Glides. Slide foot
onto -FH"TTFNCMZ and
attach with button head
machine screws. /PUFUIBU
the longest end of the foot
extends to the front
FEHFPGUIFXPSLTVSGBDF
STEP 1
45&1
STEP 2
Place assembled legs onto the underside of the
worksurface in their approximate location. Note
that mounting holes have been pre-drilled to match
the top bracket.
STEP 4
OPEN ALL PACKAGES AND VERIFY THAT YOU HAVE ALL THE HARDWARE AS INDICATED IN THE PARTS LISTING.
To assemble you will need a #3 tip Philips screwdriver and a 7/16" wrench or socket.
/PUF if table has three
legs, the center leg uses
the short Foot.
Left Leg
Right Leg
Fron
t
Fro
nt
Fro
nt
4UJòFOJOH#SBDLFU
(2-Leg tables only)